Board Logo

Ball-Joint Kombi 2.5 inch Dropped Spindles
urban_myth - March 21st, 2009 at 05:03 PM

Up for sale is another set of 2.5 inch dropped spindles for kombi, to suit balljoint beam.

$700 firm, Pick up only from Mount Pritchard (liverpool area). Contact Geoff on 0416067932 or 9711 4383

http://members.optusnet.com.au/jason_napper/kombi%20stuff/IMGP0044.JPG

LIFE IN THE LOW LANE - March 21st, 2009 at 05:48 PM

did you make these or buy them??

urban_myth - March 21st, 2009 at 07:54 PM

i make these on a regular basis.they will widen the track 13mm per side. i make them in 50mm or 65mm drop.two sets off spindles are required to make one set.i will be looking at having them cnc machined as one piece with zero offset when time permits .

66deluxe - March 22nd, 2009 at 10:59 AM

CNC ones that would be fantastic.

waltermitty - March 22nd, 2009 at 11:24 AM

what about Link spindles do you do those?

type_one - March 22nd, 2009 at 01:13 PM

If you get these cnc'd as one piece zero offset I am in for sure. You'll make a fortune as no nobody does in any where in the world as far as I know.

urban_myth - March 22nd, 2009 at 03:34 PM

i dont do link spindles

LIFE IN THE LOW LANE - March 22nd, 2009 at 06:09 PM

I'd be another for CNC'd drop spindles. I don't want to widen the track any further as going to big discs I will need all the room I can get.