Board Logo

WANTED (Cheap)
FROSTY - January 20th, 2010 at 07:31 PM

I'm after a clapped out type 3 or type 1 swing axle pan. I'm after just the rear tortion housing with spring plates and frame horns (so the front won't be used). Anywhere between Coffs Harbour and Noosa.
Please email jason.frost@surfhardware.com.au or 0403387295
Thanks
Frosty

Dasdubber - January 20th, 2010 at 07:51 PM

Torsion housing raise for the oval mate?? Sorry I can't help with a pan, hope you find one soon.
Al

matberry - January 20th, 2010 at 07:57 PM

Mmmmm........I reckon a bit of tube might get welded to this torsion housing........

Anthiron up this way had one.

FROSTY - January 20th, 2010 at 08:27 PM

quite a bit of tube will get welded to it....

LUFTMEISTER - January 20th, 2010 at 11:12 PM

Have a complete type 3 bolt in rear suspension unit. Brisbane northside $150

66deluxe - January 21st, 2010 at 06:42 PM

I have my old floorpan in the yard not getting used, $100, im in murrumba downs.

LUFTMEISTER - January 21st, 2010 at 08:24 PM

The early type 3 rear. More solid forks and torsion bars than beetle.

Wag67 - January 22nd, 2010 at 07:46 AM

I have one attached to an old buggy that i want gone so if you pick it up then it is all yours for free. seehttp://forums.aussieveedubbers.com/viewtopic.php?tid=81137&page=1#pid757863

located at Bald Hills Nth side of brisbane.

LUFTMEISTER - January 22nd, 2010 at 03:14 PM

you can't beat free. offer withdrawn.

rhrnldi - January 22nd, 2010 at 04:58 PM

There is a tonne of VW stuff on the gold coast.

Call Luke - 0413 000 702 as there are 4 garages full of stuff.

Beats travelling.