Glenn
Newcastle area NSW

Call 0411 274 155

Wrecking 1976 VW. Stripped for spares but some parts remaining

SSP 3.8 gearbox - great condition: test drive in car (if you are quick!) $300 SOLD

4x '76 wheels (4.5inch and special 37P offset) and worn tyres. Need paint: $40 the lot

1600TP engine complete with tin, clutch and rare 34carby (except alternartor and stand) runs with good oil pressure, no leaks but one pot is lazy so suitable for rebuild: SALE WITHDRAWN - I'LL MAKE IT A 1916!

Good emissions-spec fuel tank: $40

Complete wiring harness cut from car, 1976 two-switch steering column, ig switch, key and door handles (matching set), 2-speed blower/vent unit. All there except tail light pigtails: $150

Front seats (3-point mount) good for frames/bases only for fitting aftermarket seats: $40 pr. SOLD

Rear seat: no sun damage but most of the hair has fallen out; put this vinyl on another seat: $20

Other VW parts available - call and ask!

OHH NO NOT ANOTHER 76 BUG GETTING PARTED OUT NOOOOOOOO.

"Styripped"

like a horse...?

i need the head light and blinker relay i think there the same as a bus if ya have 1 post cod
thanks
if u have pm m e

hey mate what do you mean by one pot is lazy?

One pot (piston) isn't working as it should - without doing a full diagnosis, it is suffering a dud spark plug, loss of compression or burnt valve

If this is getting parted out, will you strip out the wiring loom or some of it? I am interested wiper and steering column wiring, but could be persuaded in the whole lot.

wow noones asked for the bumper yet

matt if you have no joy i think ive got a 74-76 column with all the switches and looms for wiper/indicator and ignition

I would have asked already but am broke the time being lol. from Dylan

It hasn't got a rack & pinion has it? if so, I am interested.

Glen

Whats the chassis like ???

Matt, I can strip the harness (complete - I will cut the shell rather than the loom) and sell with the steering column and door locks if you wish. The wiring has been 'cut and shut' sometime in the past to fit an ignition keypad thingo and has a few extra wires for radios etc but apart from that it should come up well - one of the reasons I bought this car was to use the wring but the fusebox doesn't fit mine. Mail order? Might be best to call me...

Jeff, no R&P as it's a flat-screen;

Dave, chassis is rooted. I may consider fixing it for another project if the $ don't add up too far, otherwise it's scrap

it would be OK if the pans are buggared

Do you still have the front bumper? If so, is it original and rust free? If so, I am interested.

If the chassis is buggered can I have the frame horns and rear torsion out of it to build a gearbox demo stand?

Have you got a 2 speed air switch? If so dibs on that.
And what condition are the headlight surrounds in?

Well? Any chance I could have the frame horns and torsion out of the wrecked pan?

PM sent

Hi Glenn,

PM sent re: steering column.

Cheers

Dave

VW dave:

Column, steering wheel, complete wiring harness (removed from car) and door latches (all with key) $150

Is it a klm speedo and working? If so how much are you asking?

Do you still have the steering shaft (I need the one with the smaller top for the steering wheel) and possibly the lower shaft as well? I will take the whole lot as you advertised it if that is how you wish to sell it, or just the shafts (that is what I would prefer).

Jeff, car has one-piece steering ckumn as it is a 76 flat-screen, but I may be able to help you with a 'small spline' L-Bug column, PM me or call

Hulby, speedo is good: check link below

http://forums.aussieveedubbers.com/viewtopic.php?tid=81825#pid761397 

PM sent.