I am after a square cut bonnet for an L bug
not this sort
this sort
It is a subtle difference but you can see it where the handle is
The square one has a more "follow the bumper" line and a bump/protusion at the bottom of the handle
I would like a straight one that requires no work - as i already have a slightly damaged one
Dont want holes welded up either
Barry
Abbotsford NSW
give me a pm and tell me what you have
Thanks
Hi Barry
They are hard to find, I wish Richard would get his finger out and make some Tupperware ones.
Steve
Any reason they are any better?
Jeff, theyre the same hood, its only a cosmetic differnce
just the sqaure cut ones were correct fitment for 75Lbugs
I got one but it doesnt fit into the paint and fit category
vws and and flatbed truck trays dont mix
I just reckon they look better - purely a personal taste
I prefer the way it follows the bumper rather than the 2 swept inserts
Pretty sure they only came out on vary late 74 and 75's
I am doing a bit of a tidy up and if I am goint to spray the bonnent I may as do the one I want and keep this one as a spare
"Richard would get his finger out "
Reckon you will finish your WRX-L first
Took note of mine today - it is the square cut one.
Haha yeah it's Funny cause i never noticed that much untill now all i rember was that our 73L had the square cut bonnet cause i always used to think
the bonnet handle shoulda been lower but then our 74L did'nt have the squarecut style bonnet. Personally i like the non square cut style but i love
all things from a 75L = ]
From Dylan
Hi
The reason that you sometimes see the later bonnet on earlier cars is because that was all that VW sold as a spare part to the panels shops after a
while.
Steve
That would be it steve cause the front end was in a crash and we replaced such as bonnet gaurds apron.
From Dylan