hi there i am selling 1set of 94 mm pistons and barrels, heads to suit they are 35x40 s/s valves and have been bored out on the inlet and exhaust ports, matched ported manfolds and twin 44idf webbers with linkage kit, brand new as41 case just needs to be machined for the larger pistons, 1 5/8 merged header with hotdog

all parts have had hardley any use and would like to sell all together

$2200 ono
chris
0411804289
st marys nsw 2760

also have push rods and tubes tinwear fan shroud generator oil tower ect that i will throw in

i have seen these heads,not just ported they have been cut and welded to get them opened up,they were built by penrose,
chris you need to get some pics up of them,

will seperate parts
44mm idf carbys complete kit $750
heads $800
pistons and barrels $200

need these parts gone

is the case solid behind #3 or a new AS41 standard?

doesn't need to be if the internals are balanced properly.

don't put bandages on an elbow for a sore knee

Were the heads purchased from Steve by any chance? - steve timms stage 1 heads with match ported manifolds?

no the heads were from wayne penrose

Hi chris!,I'll take the pistons and barrels ,as agree over the phone this morning, thanks, John.