Hi all,

I'm looking for a pair of working stock 1600 TP cylinder heads.

Need to fit stock 85.5 pistons/barrels. (So 94mm measurement inside head).


Located in Campbelltown NSW, but happy to pick up from anywhere in Sydney.

Thanks
Rob

EDITED: Looking for only dual port heads now as my current carb and manifold are knackered so good time to upgrade.

Dylan is selling a pair of heads - I don't know what sort they are though.

Here is a link to his thread. http://forums.aussieveedubbers.com/viewtopic.php?tid=86274 

If you do get them and want them brought down from Port Macquarie, I live in Port but am working in Orange at the moment, so I could bring them with me on my way back of a Sunday afternoon.

Thanks jeff, yeah I saw it, but it's too far away for me. Orange is also quite far from me too, but thanks for offering.

Hey Jeff, Im just waiting on Dylan to get back to me on the heads, does that offer stand for me if i can get hold of them?! Thanks

Rob i`ll measure the 2 sets of heads i have here ,to see the difference ,1300 are 90mm inside whilst my 1600 are 94mm

Rob,

I go through Western Sidney going between Port Macquarie and Orange, so it is no problem to drop them off.

Kieran, the same stands for you if you are on the route betweeen the 2 places.

I should see Dylan tomorrow - I will chase him up.

Thanks for checking out the measurements pod. I measured what's left of the old heads and they are 94mm also.
If I can't find a working set, I may be interested in your 1600 pair, that is if the damaged one can be repaired.

Jeff I sent Dylan a pm about the heads to see if they are still available and the right size and condition I'm after, so I'll send you a pm if all good.

Dylan is starting his first day of work experience at a custom panel shop (I think it is) today, and I have to see him this afternoon to drop off some money for some seats he sold and I delivered for him, so I will tell him to check his PM.

Bump

I did talk to him Rob, so he is aware that you are chasing them.