Board Logo

Looking for small front cut for my 70 lowlight panel
rossdanialnaumov - March 15th, 2011 at 07:36 PM

Hi guys,

I need this section for my 1970 lowlight panel. I started cutting the rust from the lower windscreen and i turns out it's had a hit right in the centre -- a heap of bog!

This is the section i need. I really only need about 2 inches down from the lower windscreen but it will be easier to join/ weld it at the air vent. Can anyone help?

See image here: http://rossandkim.com.au/window.jpg 

waveman1500 - March 15th, 2011 at 07:40 PM

That piece doesn't look too complicated, you could probably bend one up yourself out of flat sheet.

rossdanialnaumov - March 15th, 2011 at 07:42 PM

Yes but it curves both ways. I guess i can try but it would be easier if i had a cut as i know it will fit straight in.

Special Air Service - March 15th, 2011 at 08:06 PM

I "might" have this section, as well as the wheel well you where chasing earlier?

They are attached to an early lowlight at my oldies place, so I might not be able to check for about a week & a half.

I'm at Taree NSW, so obviously if you get one closer it would be easier for you. Let me know if your interested.

Cheers
Brendan

rossdanialnaumov - March 15th, 2011 at 08:22 PM

Hi Brendan,

Thanks mate. Yes i'm interested. Can you let me know if these are available. I'm back working on the car in about 4 weeks so i'd like to have them by then.

Cheers,
Ross

Special Air Service - April 8th, 2011 at 04:09 PM

Ross, check your PM box, I may be able to get these cuts for you this weekend.

Cheers
Brendan