I have a brand new engine here I have assembled for my own vehicle and will now off it up for sale . This has been sitting here for 6 months now and it has been assembled with 100% brand new parts . It has the following components ;
Magnesium as41 case , clearanced , bored and decked
AA forged 82mm 4340 race crank
AA forged 8 dowelled lightened flywheel
AA forged 94mm piston kit
AA forged cro-moly gland nut
AA 5.4'' H beam rods with ARP bolts
CB 044 CNC round port heads with 42 x 37.5 stainless valves
Engle FK 65 camshaft
Scat solid racing lifters
Scat Aluminium cam gear
Scat/Manton cro-moly pushrods
Stainless steel pushrod tubes
New Black tinware
55 Amp int. reg. Alternator
Scat welded balanced cooling fan
009 Dizzy , bosch leads
New std fuel pump/rod/spacer
Merged 1 5/8 ceramic header
Ceramic fatboy header
New 44mm IDF webbers
New CB hex bar linkage
New air cleaners
Match ported intake manifolds
Kennedy stage 1 clutch plate
Kennedy HD solid disc

This engine has a comperssion ratio of 9.07:1 and will run on any type of fuel . This engine has not been started and will need to go through the usual run-in period . This engine is priced @ $8500 and is located in Wollongong NSW . I would estimate the power of this engine to be around the 145 HP mark and will need to be dyno tuned , ROD , 02-42729920 .

oo what a bargain!!

wanna swop for a couple of kids? i have heaps of them i wouldnt miss a couple , not with that set up anyhows :o)

steff..........

Nice ...I think it may scare the crap out of my Thing!

.