Hi guys,

I'm selling up my recondition 1600 tp that I had new bearing seal and Almost ready to put in a car. Majority of the parts are all new and installed. Looking to sell it $2000 as it.this is a good price considering I've spent more than that getting it installed. The labour alone to get it put together was $400.Here are the list;
New -dual 40idf webbers with manifolds and linkagage (cleaned and jetted to suit 1600)
New - tinware
New- BMP serpentine belt kit
New- 12 volt alternator 75amp I think (had the Allen key screw installed so it is easier to remove the alternator and you don't have to drop the engine)
Reconditioned oil pump used for clearance of the alternator
New - chrome valve cover
New-petronix electronic 009 distributor
New- empi clutch kit along with new throw out bearings
New - 36hp fan housings
New- stainless steel tin screws
New- heater tubes
Heater box - used but in great condition, no leaked (tested)
1600 dp that is running and had it cleaned and the seals done. Does not leak oil.

All you need to do is get a matching exhaust and just do the general servicing eg oil and valve adjustment and you are on your way. Was going to keep this for my future project but I needs to funds to go to Japan. Pictures below. Please call me on
0412189898 and I'm based in West Sydney (Fairfield area) but can help with shipping or deliveries.

Pat









That's all I can think of atm. Everything is assembled, the only thing you would have to do is

PM SENT