To suit a 73 bay window.

I need the following:

Front interior door panels (or panel to use as template)
Sliding door interior panel
Front seats (orig or aftermarket)
Locking engine lid latch
Jack
Dynamo or alternator pulley

Brisbane preferred. Please PM if you have any of it. Thanks.

hey bud , I can lend my door card to use as a template, but i just covered it. You could still get a good plate off it, just bring over your 3 mm MDF and copy away.... I'm in Wavell Heights .........

Cheers Ian

Possibly have everything that your chasing not sure of quality except alternator generator pulley. Im located about hour west of Brisbane.

0429 333 526

what eng u got og 1600?
as alt's vary

1600 type 1 motor with an upgrade to the alternator that replaces the original genny. The pulley is a bit warped, was like that when I got the car. Not sure if any type 1 generator pulley will fit or whether they are different on the alternators.

post up a pic

pulley could be trimmed in a lathe!

I have a few door cards ranging from 70- 95% !!! front

I would imagine it would cost more to get the pulley machined than to buy a new one, most machine shops want $80 an hour without even doing much. I figured if I can't find a used one cheap I'll go new. Door cards I'm a little torn on, if I can get a set in the same colour to match mine then maybe, but the rest of my cards are showing their age too so a retrim is a real possibility. My interior is the deluxe style with the covered walkthroughs in that bone white/off white colour.

I'll post pics as soon as my camera comes back from the repairer.