Name: Steve Moran
Suburb: West Ryde, Sydney
Price: $100

I have a full crank handle setup including the pulley nut, crank receptor cage (bolt to bottom engine bolt and top head bolts) and crank handle. Also available is the rear tinware and a hole-less fan shroud (note this is 1500/1600 tinware not 1200/1300 tin). Finally there is a near NOS inlet manifold for a 1500/1600 SP engine which has had only 8 hours use and the heat risers are nice and clean. These all came off an industrial 126A motor but I beleive they would suit a Country Buggy.

Whilst I think CB's had 1200/1300 engines, these parts would let you put in a 1600SP engine and have it looking authentic, except you'd have more poke.

$100 the lot.

Can deliver to the Nationals.

Cheers

Steve















For reference here is an original crank handle on a Buggy:-



Here is the engine showing the crank handle

Hi steve p.m sent. will take these please.