After ages without touching my beetle it is time to get back into it. My beetle is stripped down and getting ready for rust repair/everything else.
A question though.
The front is a bit bent after a shunt on the passenger side, do I pull it out, risking tearing the steel or do i cut it and replace it? (slight fold above the wheel). It is a bit hard to explain without a picture.

Would it me better to buy replacement panels or find a donor car? For the front and rear aprons etc. I just don't know where to start.
Help
I need some inspiration...

What model Beetle is it? Year etc? Is it just guards etc or is it pan damage?

I think you need to post some quality pics

Will take some pics when I get the chance and post.