Board Logo

Golf Steel Rims 6jx15 ET47 on T3 Syncro
Down_under_23 - September 13th, 2011 at 02:47 PM

Hi there!

I purchased 4x 6Jx15 ET47 5/112. What do i have to do to make them fit on a Syncro.

I read that it's possible to fit ET45 from Audi and VW on the Syncro. No mods, only a 5/16 spacer??

Is it possible to customize the rims, reduce them to ET ??? whatever is needed?

Thanks for Response.

Cheers

Seb


I heard that it's illegal to drive spacers..even the skinny ones? Sad

Ben386 - September 13th, 2011 at 06:42 PM

Seb,I wouldnt use them.
Off-set is too large.Will need spacers,longer wheel studs.
GVM is wrong.
Wheel spacers are illegal.
Try some Mefro ones from Syncro Services.

Ben386 - September 13th, 2011 at 06:51 PM

Seb,also,I run Audi 16x7,et 42(i think),no spacer,no probs on my Syncro.
The rear have no centre caps.

Ben386 - September 13th, 2011 at 06:54 PM

Just checked,et 42.

veesub - November 17th, 2012 at 05:12 PM

Quote:
Originally posted by Ben386
Seb,also,I run Audi 16x7,et 42(i think),no spacer,no probs on my Syncro.
The rear have no centre caps.

HI I HAVE 89 CARAVELLE WITH AUDI 16X7 ET42 TYRE 225/75 I BOUGHT THE CAR LIKE THIS IT HAS SPACER PLATES AND WORST MOD TO CONTROL ARM WHAT SIZE TYRES ON YOUR AUDI RIMS THX

barls - November 17th, 2012 at 05:26 PM

being the original thread is over a year old and the poster hasnt been seen for over a year as well. dont thing you will get an answer