Board Logo

WTB for '72 type 3 square
karmann54 - January 29th, 2008 at 10:38 AM

I've put this in the spare parts forum as well....

WTB for '72 Type 3 square

I've just got a '72 square on the road and need some bits and pieces. Brisbane preferably, although the smaller bits could be posted.

- windscreen and chrome trim (and if someone has a new rubber left over, otherwise I'll just get one from one of the VW shops)
- rubber mat for rear storage area
- black knob for the drivers seat tilt adjustment
- oil-bath air filter inlet rubber sleeve (for a 1500 single carb engine, side draft Solex 32PHN carby)

There will no doubt be more as time goes on. There is a bit of a rattle from the passenger side engine support but need to look at it more before I know what I need.

Angus, 0412 105 789 or just post reply/PM.