Board Logo

raising a type 3
JONNYVW - April 3rd, 2007 at 04:01 PM

i am sick of bottoming out on big pot holes and so on. I brought the type 3 square low, so i was just wondering if anyone had anytime over easter to help me raise it?

im in the south east of melbourne!

im available on 0417 148 384 if you would like to call


bus914 - April 3rd, 2007 at 08:20 PM

greedy53 - June 4th, 2009 at 07:55 PM

there not to hard as they use torson bars both ends i know so does bugs but these are a bit easyer
jack it up one end and remove all wheels shocks and anything that looks like it will be a problem take cover plates of and mark the position of everything with a grinder using a very this cutting disk only a small cut across all parts