Hello everyone
Chasing a 32-34 PDSIT (right side) carby bowl with good thread to snug down the idle cut-off solenoid (unlike mine which is stripped). Preferably just the bowl if you've got a spare or otherwise the complete carby - ideal if I could pick up from someone located in South East QLD but willing to pay for freight if you're willing to ship.
Cheers.

If you can't find one closer to home I should have either a complete carb or a centre section in Taree.

Thanks Grumble
I've sent a PM -not sure if it has gone through (no record in my outbox) -so I'll try again. Apologies if you get multiple messages!

No worries I got the message and have answered.

I had the same problem with my type 3 carbs, I used this section from a set of bay windows carbs, I changed over the jets and fittings. It worked but there were some temperature bulbs on the float bowls that were different.

If I remember it was only this section that was compatible with mods.

Was the throat size different in the Bay window carbs?