I know this is abit of a long shot.... but someone out there has the KO off the country buggy i now own.
Going off the video from when they were found they had the numbers still there... i own the one that was cut in half and it has passed through many
hands befor my ownership but im hoping someone is holding onto the KO number and the I.D. plate the rivets under the dash and is willing to sell it up
to go back to its original body.
http://www.youtube.com/watch?v=ytFZrjDxdUo
i plan to get this thing back on the road in the near future but without these i think obtaining a roadworthy will be very hard.
any help will be muchly appreciated and if someone puts me onto the person with these im offering a 6 pack of beers of your choice
for the finders fee
Myles,
I now abit about the history of these two vehicles. The last owner I know was Dutchy who lives in Sydney,. He is overseas at the moment but I will
send him an email to see if he can shed some more light on KO386.
From what I saw on the video there is a shitload of work to bring this CB back to anything that resembles a CB. I guess you must have full access to
someone who can handle the panel fabrication.
One thing, you will not need any reference to the KO # on the vehicle if you are trying to register it. This number was a production # only and was
never recorded by any of the Motor Traffic Boards across Australia.
If you don't have an ID plate then talk to me as I may be able to help although I don't have plate # 118310305 which was the original ID plate that
came with KO 386.
Would need to match Chassis # with stamp on transmission tunnel.
Let me know if I can help by email at countrybuggybill@hotmail
Thats going to be a lot of work. Look forward to seeing your progress
Young fella is more than up to the task of putting this back together, goes alright he does,
Nath
| Quote: |
Gday Myles,
this may be of some comfort to you should you not find id plate. As a rwc vehicle inspector, i can assure you, you wont need the plate to register the
car as it is pre compliance and it is almost a free for all when it comes to ID all you need is stamped chassis # an engine # and a rwc (Qld Vic and
blue slip NSW) I know it is far better value wise to have the plate but stamped numbers (what ever they may be or need to be) are all is needed for
reg
good luck with the hunt
Fraser