Posts: 208
Threads: 26
Registered: July 30th, 2012
Member Is Offline
Location: Canberra ACT
Theme: UltimaBB Pro Blue ( Default )
Mood: good
posted on February 25th, 2013 at 03:06 PM
brakes help
hi guys,
looking at doing a brake upgrade and stud change on my 70 bug. what type is the front, ball joint or link pin?
and what is the rear(will change to disks) long swing, or what??
they have blanks too, so can always get them drilled..
thanks
just because its a kit car... doesnt mean its not a vw!
bajachris88
A.k.a.: Chris Leete
23 Windows of Awesome
The international telephone dialing code for Antarctica is 672.
Posts: 6661
Threads: 534
Registered: April 8th, 2005
Member Is Offline
Location: Tanah Merah, SE-QLD
Theme: UltimaBB Pro Blue ( Default )
Mood: A bee bit ma' bottom, now ma' bottom's big!
posted on February 25th, 2013 at 03:58 PM
Assuming original pan:
Front is ball joint - 4 stud, assuming its 1500 series with torsion beam front suspension, not an early super bug with struts.
rear depends. Could be swing axle if an original 1500 manual, or IRS if an early super bug or import semi automatic originally. Look under the car for
'trailing arms' to denote whether rear is IRS or not.
IRS will also have CV joints on the drive shafts, so you should see boots on inner and outter CV joints. Swing axle just has boots on the gearbox end
and a solid shaft on the outter, with bolts down the seam of the boot to hold it together as the boot wraps around.
(ô_!_/ô) (ô_!_/ô)
69' baja: kombi box, thing spindles, irs, disc front, type 3 rear drums, 2 inch lift kit, 31x10 rears.
New engine in process: 94mm p&bs, 74mm C/w chomol Crank, 35.5x39 SP heads, turbo. Wierd combo, hopeful torque monsta!
