Posts: 169
Threads: 22
Registered: July 2nd, 2006
Member Is Offline
Location: NZ
Theme: UltimaBB Psyche Red
posted on April 25th, 2013 at 02:11 PM
Angleflow Heads 4"
Hi,
I know this isnt the FS section but its a small market.
These are in the US at the moment, Jeff Denham ported heads, 52 x 40 valves, 4" bore, six stud. New never used, they cost me 3k US, looking for
offers around there somewhere ? Freight included in that price.
I bought a complete longblock so dont need these. Would consider swaps or other offers also.
I also have a line on a matching case (Denham) and 90mm flanged crank and flywheel, 5.7" rods (probably a bit short) for another 3k if it helps.
Thanks
Adrian
mike64
Officially Full-On Dubber
Posts: 395
Threads: 37
Registered: November 10th, 2006
Member Is Offline
Location: Campbelltown
Theme: UltimaBB Pro Blue ( Default )
Mood: Just Great, up to the eyeballs in it
posted on April 26th, 2013 at 10:44 PM
Hey Adrian, we were talking about Angelflow's a while back, what case is it he used? and what brand of crank?
Now... what was I doing again
55slug
Seriously Crusin Dubber
Posts: 169
Threads: 22
Registered: July 2nd, 2006
Member Is Offline
Location: NZ
Theme: UltimaBB Psyche Red
posted on April 27th, 2013 at 10:34 AM
Quote:
Originally
posted by mike64
Hey Adrian, we were talking about Angelflow's a while back, what case is it he used? and what brand of crank?
CB case undrilled, welds on it a bit, bores for 4" and six studs it ( WBX pattern). Case has had the centre main thrust conversion by jaycee, Crank
is a Scat.
mike64
Officially Full-On Dubber
Posts: 395
Threads: 37
Registered: November 10th, 2006
Member Is Offline
Location: Campbelltown
Theme: UltimaBB Pro Blue ( Default )
Mood: Just Great, up to the eyeballs in it
