| [ Total Views: 686 | Total Replies: 12 | Thread Id: 104319 ] |
|
|
 davidr
Casual Dubber
Posts: 26
Threads: 13
Registered: October 11th, 2011
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on December 8th, 2013 at 11:52 AM |
|
|
Swing axle Internals...??
Hey guys,
I scored a type 3 swing axle to do a conversion on my bus. One of the rubber boots was missing and some of the oil laying around looked a bit watery.
So I popped the side plate off yesterday and found this corrosion and small crack.
I believe the box hasn't been in a vehicle for some time but was apparently going fine up until then.
Wondering if anyone has some advise weather or not to put it in and see how it goes, or should I be looking at replacing some bits first.
Hope someone can help.
Thanks heaps.
|
|
|
hellbugged
A.k.a.: Daimo Pell
23 Windows of Awesome
48's and straight cuts
Posts: 5080
Threads: 116
Registered: April 17th, 2003
Member Is Offline
Location: Nambucca Valley NSW
Theme: UltimaBB Psyche Blue
Mood: Couldn't care less
|
| posted on December 8th, 2013 at 12:44 PM |
|
|
Just give it a go
Might find other issues with shifting etc anyhow.... At least then if you go the fixing route, you can tend to any other issues in the one go
|
|
|
Craig Torrens
A.k.a.: Craig Torrens
Scirocco Rare
6 times Australian, 7 times State Hillclimb Class Champion
Posts: 8040
Threads: 347
Registered: January 10th, 2003
Member Is Offline
Location: Sydney
Theme: UltimaBB Pro Blue ( Default )
Mood: Time to go Salt lake racing, and actually achieve a result.
|
| posted on December 8th, 2013 at 12:57 PM |
|
|
I have another diff you can have if that helps....just let me know.
|
|
|
 matberry
Super Moderator
Go hard or go home
Posts: 8114
Threads: 134
Registered: March 7th, 2006
Member Is Offline
Location: Cooroy Qld
Theme: UltimaBB Pro Blue
Mood: enjoying waving at all my Kombi buddies from my T3
|
| posted on December 8th, 2013 at 01:09 PM |
|
|
mmm 3 people, 3 opinions. IMO if you run that it will DIE very quickly, if it isn't already. Not the crack in the side gear, not sure that it would
be a problem, but all that corosion will make short work of wrecking anything that is good, it's like filling your gearbox oil with sand paper!!!
Matt Berry Motorsports...air cooled advice, repairs and mods Ph 0408 704 662
OFF-ROAD,CIRCUIT,DRAG,STREET,ENDURANCE
 |
|
|
Craig Torrens
A.k.a.: Craig Torrens
Scirocco Rare
6 times Australian, 7 times State Hillclimb Class Champion
Posts: 8040
Threads: 347
Registered: January 10th, 2003
Member Is Offline
Location: Sydney
Theme: UltimaBB Pro Blue ( Default )
Mood: Time to go Salt lake racing, and actually achieve a result.
|
| posted on December 8th, 2013 at 02:30 PM |
|
|
I didn't give an opinion, just offered free parts 
|
|
|
HappyDaze
A.k.a.: Greg Mackie
Son of Jim - Creator of Good
Superannuated
Posts: 2887
Threads: 141
Registered: June 13th, 2009
Member Is Offline
Location: Southern Highlands NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: Happy enough
|
| posted on December 8th, 2013 at 03:26 PM |
|
|
It would be a shame to ruin a good gearbox [if it is a good gearbox?] for the sake of swapping diffs.
Craig has made a generous offer, why not do it properly?
I'd rather wear a Beetle out by racing it than by polishing it!
|
|
|
davidr
Casual Dubber
Posts: 26
Threads: 13
Registered: October 11th, 2011
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on December 8th, 2013 at 03:37 PM |
|
|
Thanks gents.
I was considering putting it in for a full rebuild at some stage anyway. Is it safe to say if I do a rebuild it comes back as good as new.?
Any suggestions of someone in or near Brisbane that could do it and approx. cost.?
Thanks again.
|
|
|
matberry
Super Moderator
Go hard or go home
Posts: 8114
Threads: 134
Registered: March 7th, 2006
Member Is Offline
Location: Cooroy Qld
Theme: UltimaBB Pro Blue
Mood: enjoying waving at all my Kombi buddies from my T3
|
| posted on December 8th, 2013 at 05:23 PM |
|
|
See Dangerous on here
Matt Berry Motorsports...air cooled advice, repairs and mods Ph 0408 704 662
OFF-ROAD,CIRCUIT,DRAG,STREET,ENDURANCE
|
|
|
davidr
Casual Dubber
Posts: 26
Threads: 13
Registered: October 11th, 2011
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on December 8th, 2013 at 05:42 PM |
|
|
Thanks Matt.
Craig, Greg.. I have never had anything to do with swing axle so have no idea. Swapping diffs, doing it properly ?
Is the dif something that can be just swapped over.?
Thanks.
|
|
|
HappyDaze
A.k.a.: Greg Mackie
Son of Jim - Creator of Good
Superannuated
Posts: 2887
Threads: 141
Registered: June 13th, 2009
Member Is Offline
Location: Southern Highlands NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: Happy enough
|
| posted on December 8th, 2013 at 06:38 PM |
|
|
Dangerous is the man...he just did my swing-axle box for No.8 Beetle.
And he's a lot closer to you. 
I'd rather wear a Beetle out by racing it than by polishing it!
|
|
|
hellbugged
A.k.a.: Daimo Pell
23 Windows of Awesome
48's and straight cuts
Posts: 5080
Threads: 116
Registered: April 17th, 2003
Member Is Offline
Location: Nambucca Valley NSW
Theme: UltimaBB Psyche Blue
Mood: Couldn't care less
|
| posted on December 8th, 2013 at 07:13 PM |
|
|
Oops, didnt see the corrosion 
|
|
|
dangerous
A.k.a.: Dave Butler Muffin Man
23 Windows of Awesome
Posts: 5901
Threads: 178
Registered: January 6th, 2005
Member Is Offline
Location: Gold Coast
Theme: UltimaBB Pro Blue ( Default )
Mood: 591
|
| posted on December 8th, 2013 at 08:50 PM |
|
|
Yeah that corrosion is ugly, as is the cracked washer.
The rust shows where the high tide mark is.
Both should be addressed before use.
Unfortunately I am booked out till mid March next year.
| Quote: | Originally
posted by westi
That's mad Alan.
|
|
|
|
vlad01
Compulsive Aussie Vee Dubber
Posts: 4270
Threads: 109
Registered: June 3rd, 2010
Member Is Offline
Location: Kyneton, VIC
Theme: UltimaBB Pro Blue ( Default )
Mood: Side ways
|
| posted on December 12th, 2013 at 08:39 AM |
|
|
| Quote: | Originally
posted by matberry
mmm 3 people, 3 opinions. IMO if you run that it will DIE very quickly, if it isn't already. Not the crack in the side gear, not sure that it would
be a problem, but all that corosion will make short work of wrecking anything that is good, it's like filling your gearbox oil with sand paper!!!
|
the crown teeth will just shatter under load I reckon.
that box is stuffed. I would jut toss it. there might be some good bits in it but I doubt it, prolonged moisture will damage harden steel alloys
found in a box.
71 notchback,
Past owner of, 70 NB, 73 SB and 72 FB TLE |
|
|
