Subject: Fitting Kadron Manifolds to Twin Port Type 1 motor
mossman
Commited Dubber
Posts: 73
Threads: 30
Registered: April 6th, 2013
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
posted on October 22nd, 2014 at 04:00 AM
Fitting Kadron Manifolds to Twin Port Type 1 motor
The Kadron manifolds for a twin port motor dont have the hole for the locating lug on the heads that the original banana manifolds do.
Should I grind the locating lug in the heads down or drill a hole in the aluminium manifold?
Bizarre
Super Moderator
The artist formerly known as blue74l
Posts: 12737
Threads: 730
Registered: August 25th, 2002
Member Is Offline
Location: Abbotsford, Sydney
Theme: UltimaBB Pro Blue ( Default )
posted on October 22nd, 2014 at 08:43 AM
A good set of multi grips should be able to pull the pin out.
That is what I did.
Futue te ipsum!!!
mossman
Commited Dubber
Posts: 73
Threads: 30
Registered: April 6th, 2013
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
posted on October 24th, 2014 at 12:00 PM
Thanks Bizarre. Removed them with vice grips after freeing them up with a hammer.
