Subject: Engineering certificate, registration in NSW
dmitri
Learner Dubber
Posts: 1
Threads: 1
Registered: April 28th, 2015
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
posted on April 28th, 2015 at 12:17 PM
Engineering certificate, registration in NSW
Hi,
I would like to buy a "chop top" Superbug classic Beetle, replace it's engine and register the car in NSW.
I was told that I would need to get an engineering certificate for new modification as well as for all previous modifications regardless whether the
car had been registered before or not.
I was also told that chop top would need to pass torsion and bending tests.
Is my information correct?
How hard is to get an engineering certificate for "chop top" mod (provided that engine modification is approved)? Is that possible at all?
If a chop top car doesn't pass tests does that mean that the car would be written off? I guess possibility of improvement on an old chop top job
would be questionable. Would you agree with that?
Please let me know if this is a wrong forum to ask these kind of questions.
Thank you.
1303Steve
A.k.a.: Steve Carter
Scirocco Rare
Posts: 8621
Threads: 556
Registered: August 27th, 2002
Member Is Offline
Location: Sydney, NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: Parrot Heading
posted on April 28th, 2015 at 12:45 PM
Hi
If it was registered in NSW old engineers reports are still valid if you have it, if it was registered interstate a new certificate would be needed.
Most chop tops rust like mufflers, from the inside out, so have good look at it before spending any money on it.
Steve
helbus
A.k.a.: Pete S
Super Administrator
Mad fabricator, paint and body
Posts: 7386
Threads: 312
Registered: September 1st, 2002
Member Is Offline
Location: In the garage chopping cars into bits
Theme: UltimaBB Pro Blue
Mood: In the thinking chair
posted on April 28th, 2015 at 06:31 PM
I am involved in a chop top, and a pre cut torsion and bending test was required $880. Then another test will be done once the body work is completed,
then a final inspection. This is in Victoria. It is really easy, just taking about 5 years to make it look correct like a factory 'convertible' not
a 'chop top'
