| [ Total Views: 1558 | Total Replies: 3 | Thread Id: 109215 ] |
|
|
 Bone
Officially Full-On Dubber
Posts: 299
Threads: 43
Registered: August 9th, 2009
Member Is Offline
Location: Cooroy
Theme: UltimaBB Pro Blue ( Default )
|
| posted on June 8th, 2015 at 07:50 AM |
|
|
Ej22 Gen 1 and Gen2.
Could someone please tell me if the early 1992 ej22 gen1 engine could go into a 96 liberty with a gen2 engine as my son's mate has cooked his and
seen my spare Baja gen1 engine on the shed floor. Is it only the engine loom that is different?
Cheers.
|
|
|
mackaymanx
A.k.a.: Brent
Custom Title Time!
Posts: 1611
Threads: 97
Registered: January 12th, 2006
Member Is Offline
Location: Mackay.QLD
Theme: UltimaBB Pro Blue
Mood: Brad'ed Off 
|
| posted on June 8th, 2015 at 08:57 AM |
|
|
The easiest way is to change the intake manifold over. Knock sensor/ cam & crank sensors and of course the wiring loom are different.
Quote of the week
"Do I wish to send them to you again, nope, no interest can't be bothered really, to much hassle for little or no return."
 |
|
|
mackaymanx
A.k.a.: Brent
Custom Title Time!
Posts: 1611
Threads: 97
Registered: January 12th, 2006
Member Is Offline
Location: Mackay.QLD
Theme: UltimaBB Pro Blue
Mood: Brad'ed Off
|
| posted on June 8th, 2015 at 09:12 AM |
|
|
When I do an install i go through these things-
cam seals
crankshaft/pulley seals
oil pump o-ring
o-ring at rear of rh head/front of lh head
gudgeon pin access plugs front of engine(yes they do leak sometimes)
gudgeon pin access plate o-ring rear of engine
oil separator plate
clean idle control valve
replace vacuum lines on manifold(silicon)
timing belt/water pump if necessary
you don't have to do all this but I find these are the source of some leaks/problems
Quote of the week
"Do I wish to send them to you again, nope, no interest can't be bothered really, to much hassle for little or no return."
|
|
|
Bone
Officially Full-On Dubber
Posts: 299
Threads: 43
Registered: August 9th, 2009
Member Is Offline
Location: Cooroy
Theme: UltimaBB Pro Blue ( Default )
|
| posted on June 8th, 2015 at 12:03 PM |
|
|
Thanks Brent
|
|
|
