| [ Total Views: 723 | Total Replies: 3 | Thread Id: 109616 ] |
|
|
 Strogger
Casual Dubber
Posts: 47
Threads: 8
Registered: February 15th, 2015
Member Is Offline
Location: Brisbane South Side.
Theme: UltimaBB Pro Blue ( Default )
|
 posted on August 9th, 2015 at 06:53 PM |
|
|
End play - new fly wheel
Hi Team,
Had a flywheel with a trashed ring gear.
Replaced with a brand new part out of the box, also replaced rear main oil seal and oring on the crank.
Left existing shims in situ and installed new flywheel torquing glad nut to spec.
Yanking on the front pulley doesn't give any feeling of movement.?
The web says don't re shim on an old engine, but is this accurate or am I paranoid.?
Engine turns over by hand with normal effort, not binding or sticking..
Appreciate thoughts before I go to far (engine mounted, but pan still separate from car)
Thanks, Anthony.
|
|
|
 Bizarre
Super Moderator
The artist formerly known as blue74l
Posts: 12755
Threads: 731
Registered: August 25th, 2002
Member Is Offline
Location: Abbotsford, Sydney
Theme: UltimaBB Pro Blue ( Default )
|
| posted on August 9th, 2015 at 06:58 PM |
|
|
g'day
You have changed the flywheel so you need to reset it.
The flywheels will be different
"The web says don't re shim on an old engine" - this is for when EVERYTHING is the same
Futue te ipsum!!!
|
|
|
Strogger
Casual Dubber
Posts: 47
Threads: 8
Registered: February 15th, 2015
Member Is Offline
Location: Brisbane South Side.
Theme: UltimaBB Pro Blue ( Default )
|
| posted on August 9th, 2015 at 07:08 PM |
|
|
Hey, thanks for the quick reply..
I knew it was too good to be true.
So engine comes back out and clutch / flywheel off. Sigh..
Lucky it's a public holiday up here on Wednesday and I took mon / tues off.. 
|
|
|
vduboy
Insano Dub Head
Posts: 702
Threads: 41
Registered: October 6th, 2012
Member Is Offline
Theme: UltimaBB Streamlined2
Mood: Dying to get more buggy building time..
|
| posted on August 11th, 2015 at 12:46 PM |
|
|
Before you pull it back out, back off your clutch arm and measure the free play with a dial gauge, you might get lucky and it might be within spec.
It will all be OK in the end, if it's not OK it's not the end!
|
|
|
