| [ Total Views: 605 | Total Replies: 4 | Thread Id: 110096 ] |
|
|
 64blackbettle
Commited Dubber
Posts: 51
Threads: 17
Registered: March 12th, 2012
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on November 10th, 2015 at 02:32 PM |
|
|
Heater Cable Knob setup - 64 Beetle
I've inserted new heater cables into my 64 beetle - which was a challenge cause the tubes were dirty, but WD40 and some stiff wire cleaned them out.
So heater cables inserted and now coming out at the rear with the loop at the ivory knob end which is where i have the issue.
How the hell does this mechanism work. I assume that by turning the knob that the cables should pull up which then pulls the cable through the tubes
which opens the flap in the heat exchanger and heat starts flowing.
I've followed the diagram but nothing?
Hope someone can help?
Should the cable twist or pull straight up. No Idea
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
|
|
|
 vw54
Super Administrator
Always Waiting 4 Friday
Posts: 16723
Threads: 378
Registered: August 26th, 2002
Member Is Offline
Location: Sunny Sydney
Theme: UltimaBB Pro Blue ( Default )
Mood: Oval resto ongoing
|
| posted on November 10th, 2015 at 04:11 PM |
|
|
looks like you have the end through the pin
when it fitted you will see it slide up inside the outer section use plenty of grease
|
|
|
64blackbettle
Commited Dubber
Posts: 51
Threads: 17
Registered: March 12th, 2012
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on November 10th, 2015 at 06:43 PM |
|
|
So does the cable slide up and down between the threaded sleeve #6 and spindle item #5?
|
|
|
psimitar
Son of Jim - Creator of Good
Posts: 2506
Threads: 148
Registered: January 1st, 2009
Member Is Offline
Location: North East Melbourne, VIC
Theme: UltimaBB Psyche Blue
|
| posted on November 11th, 2015 at 12:52 AM |
|
|
Yes. centre of cable loops over the pin in the threaded casing #6 and is pulled up by the thread motion and pulled down by the heat exchanger return
springs when the threaded control knob releases tension.
The pin should also face in the vertical plane and not sideways so the cable pulls equally.
madness is in the eye of the beholder  |
|
|
hellbugged
A.k.a.: Daimo Pell
23 Windows of Awesome
48's and straight cuts
Posts: 5080
Threads: 116
Registered: April 17th, 2003
Member Is Offline
Location: Nambucca Valley NSW
Theme: UltimaBB Psyche Blue
Mood: Couldn't care less
|
| posted on November 11th, 2015 at 09:30 PM |
|
|
One side of the cable should be longer
Goes to the left side of the car
|
|
|
