Subject: Stabiliser bar bushing replacement question
cwatts181
Casual Dubber
Posts: 21
Threads: 4
Registered: February 1st, 2010
Member Is Offline
Location: Sydenham
Theme: UltimaBB Pro Blue ( Default )
posted on February 13th, 2016 at 05:33 PM
Stabiliser bar bushing replacement question
Hi folks
I have a 73 Kubelwagen - it has a wobble at around 80klm/h that I'm try to fix so am slowly going thru the front end fixing things.
Today's job was stabilizer bar bushings, like everything with these old cars a quick job becomes a whole weekend. When I try to attach the new rubber
bushings to the torsion bar by way of the metal clip that goes around the torsion bar and the rubber bushing, it's a super tight fit, so the
surrounding bracket needs to be somehow compressed to allow the small metal locking clip to slide on. My question is in order to compress the bracket
around the rubber bushing it seems to me I need to use so much force I'm going to distort the shape of the bracket... I'm using vice grips to
gradually compress the bracket but damned if it's not bending the metal. Is there a trick to this? Or a special tool required? The original bracket
seems to be a slightly thinner metal and much more perfectly shaped. New bushing and old bushing are same size ( old one shows excessive wear) . Any
advice is greatly appreciated!
psimitar
Son of Jim - Creator of Good
Posts: 2506
Threads: 148
Registered: January 1st, 2009
Member Is Offline
Location: North East Melbourne, VIC
Theme: UltimaBB Psyche Blue
posted on February 13th, 2016 at 10:49 PM
What about some 12mm bits of hardwood and a large G-clamp? The hardwood will spread the load of the g-clamp heads.
madness is in the eye of the beholder
cwatts181
Casual Dubber
Posts: 21
Threads: 4
Registered: February 1st, 2010
Member Is Offline
Location: Sydenham
Theme: UltimaBB Pro Blue ( Default )
posted on February 15th, 2016 at 08:21 AM
These videos make it look like a five minute job - In the Chris Malone video he coats the rubber in WD40 - so I tried this and it really changes the
way the rubber behaves under pressure. Instead of sticking and pinching they kind of slip under the bracket and behave nicely. Anyway it seemed to
work.
