| [ Total Views: 1105 | Total Replies: 3 | Thread Id: 112651 ] |
|
|
 pv370
Officially Full-On Dubber
Posts: 272
Threads: 38
Registered: April 7th, 2014
Member Is Offline
Location: Goulburn NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: Southern Comfortably Numb
|
| posted on July 25th, 2017 at 06:32 PM |
|
|
32 phn tuning help
does this sound right ??????
1. engine at operating temp then stop motor
2. turn mixture screw in until stop (gently) then back out 1.5 turns
3.start motor then idle screw until desired idle speed.
4. mixture screw in till idle slows then out half a turn
5. readjust idle
cant find anything in the workshop manual
Cheers Peter
|
|
|
 vw54
Super Administrator
Always Waiting 4 Friday
Posts: 16723
Threads: 378
Registered: August 26th, 2002
Member Is Offline
Location: Sunny Sydney
Theme: UltimaBB Pro Blue ( Default )
Mood: Oval resto ongoing
|
| posted on July 25th, 2017 at 10:21 PM |
|
|
yep sounds good as long as the ignition timing is right which may take a bit of experimenting and adjusting the carby again
|
|
|
ACE76
Seriously Crusin Dubber
Posts: 105
Threads: 19
Registered: August 4th, 2005
Member Is Offline
Location: Victoria
Theme: UltimaBB Pro Purple
Mood: ACE 30 FOR SALE!
|
| posted on August 1st, 2017 at 06:31 PM |
|
|
You need to SET the valve clearances (equal on all intakes, AND equal on all exhausts) -- & get timing, dwell etc right first for good results
too!
ACE 30 & ACE 40 oil: specially formulated for your Air Cooled Engine...
Delivery free Outer Eastern Melb. & Dandenong Ranges.
from$19 for 2.5L (spot-on for 1 fill, re-use bottle to measure), or $29 for 5L (2 fills)
|
|
|
pv370
Officially Full-On Dubber
Posts: 272
Threads: 38
Registered: April 7th, 2014
Member Is Offline
Location: Goulburn NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: Southern Comfortably Numb
|
| posted on August 2nd, 2017 at 09:03 PM |
|
|
thanks for the replies......
i was having trouble with the motor stalling when slowing down for turning corners in town.
also rough idle after the engine had warmed up and the choke had cut out.
read somewhere that too rich a mixture would cause these problems and its seems they were right. (touch wood all is good now)
mixture screw seemed to be wound out about 4 turns or more , so running rich
i wasnt exactly sure if the above procedure was correct as i couldnt find anything in the manual.
thanks again Peter
|
|
|
