Board Logo
Go To Bottom

Printable Version  
[ Total Views: 1387 | Total Replies: 9 | Thread Id: 13087 ]
Author: Subject: Neil Neil Orange Peel
Member64Samba
Learner Dubber
*


Avatar


Posts: 12
Threads: 4
Registered: July 31st, 2003
Member Is Offline

Location: Watford, London, ENGLAND
Theme: UltimaBB Pro Blue ( Default )
Mood: Covered in old

posted on September 9th, 2003 at 06:24 AM
Neil Neil Orange Peel


Just got an HVLP spray gun. When spraying a rear wing the paint came very orange peely. Can it be that the paint was too thick? The panel was thourghly wiped down beforehand and was very clean. I flatted it back to try again and on the second attempt the same happened.

Any advice??

Thanks in advance

Jay




Jay
MemberSKEWtYpe3
Custom Title Time!
*****


No Avatar


Posts: 1859
Threads: 107
Registered: August 26th, 2002
Member Is Offline

Location: Vic
Theme: UltimaBB Pro Blue ( Default )
Mood: Stiring The Pot

posted on September 9th, 2003 at 09:12 AM


just guessing here......
air temperature and moisture in air ?
correct mixing on the bottles wont work for the temperature i hear
ask your local body shop maybe
:bounce
Super Administratorvw54
Super Administrator
Always Waiting 4 Friday
*********

Rank Avatar

No Avatar


Posts: 16723
Threads: 378
Registered: August 26th, 2002
Member Is Offline

Location: Sunny Sydney
Theme: UltimaBB Pro Blue ( Default )
Mood: Oval resto ongoing

posted on September 9th, 2003 at 10:05 AM


Quote:

When spraying a rear wing the paint came very orange peely



What sort of Aircraft where you painting HAHAHA Wings indeed

We have MUDGUARDS here in Aussie

Most proberly you had the paint too thick or you applied a too heavy coat

I have found thin coats applied with drying time inbetween to be the best method to reduce orange peel.

You could block the paint down when its dryed and apply a pissy thin coat, this method is called flow coating and gives a flat no peel finish.




MemberDoug Sweetman
Veteran Volks Folk
Nil Bastardo Carborundum
*****


Avatar


Posts: 2128
Threads: 58
Registered: September 23rd, 2002
Member Is Offline

Location: Perth, W.A
Theme: UltimaBB Pro Blue ( Default )
Mood: sweeeeet :)

posted on September 9th, 2003 at 10:18 AM


I'm assuming that when you say you wipe the panels down, you use a tack cloth to get any dust particles, and then a good wipe with a suitable solvent (cant think of the brand name off the top of my head) to remove any oils or waxes ?

What type of paint are you using - acrylic enamel or 2pak ?
MemberDubCrazy
A.k.a.: steff
Custom Title Time!
*****


Avatar


Posts: 1295
Threads: 145
Registered: July 18th, 2003
Member Is Offline

Location: Gladstone Qld
Theme: UltimaBB Pro Blue
Mood: painting anything in front of me

posted on September 9th, 2003 at 05:20 PM


it sounds like you have your air pressure to low,thats if you are spraying 2 pac. Orange peel noramly happens when then paint is applyed to thin and dry or if the paint is to thick and its not flowing out.what paint are you useing with what mix ratio? E.G. 2/1+10% or 3/1+10% etc. All so what air supply are you useing? is it man enuf to run your spray gun with out fading off becasue that can cause a pressure drop and orange peel. another thing, make sure that you gun is set up right as a HVLP gun is very different to any other sort .Are you useing a clear over base or a direct gloss? as a clear will always have a very slight peel affect but you can lose that by applying a flow coat (i highly thinned coat of clear) as your last coat.... hope this helps you out some.. if your still having dramas i'll help you out as best i can..............................
MemberLOWBUG
Insano Dub Head
****


Avatar


Posts: 738
Threads: 33
Registered: July 9th, 2003
Member Is Offline

Location: SYDNEY
Theme: UltimaBB Pro Blue ( Default )
Mood: OUT OF CONTROL

posted on September 9th, 2003 at 09:31 PM
HVLP


HVLP guns are a pain in the ass. Chuck it away.

But seriously they are a difficult gun to use espesially for the novice.
There designed to use large amounts of air volume at low pressure, then you get bad atimization that is large paint drops and lost of peel.

You'll have to mess around pressure and thinner mixes they are designed to reduce overspray and paint wastage.

Try reducing your material flow(paint flow) and move a little slower with you passes, but be carefull of runs in your paint nobody likes donny's
Memberfrog
Wolfsburg Wizard
***


Avatar


Posts: 571
Threads: 49
Registered: February 26th, 2003
Member Is Offline

Location: Moffat Beach QLD
Theme: UltimaBB Pro Blue ( Default )
Mood: is what the cow did yesterday.

posted on September 9th, 2003 at 10:28 PM
Not about paint.


Neil...Neil..........orange peel..........If only I could see you again.....Rik says,must say I have not heard that line for a while.
I know nothing about paint though.




"-Hannovermetalmadness-"(Infectious desease with no known cure).
Member64Samba
Learner Dubber
*


Avatar


Posts: 12
Threads: 4
Registered: July 31st, 2003
Member Is Offline

Location: Watford, London, ENGLAND
Theme: UltimaBB Pro Blue ( Default )
Mood: Covered in old

posted on September 10th, 2003 at 10:33 PM


What is the best mix of paint to thinners for the top coat of paint?? I'm using cellulose paint.



Jay
Member64Samba
Learner Dubber
*


Avatar


Posts: 12
Threads: 4
Registered: July 31st, 2003
Member Is Offline

Location: Watford, London, ENGLAND
Theme: UltimaBB Pro Blue ( Default )
Mood: Covered in old

posted on September 12th, 2003 at 08:08 AM


The paint was too thick!!!

Rear wings ( or mud guards) are nice and shiny blue........just a couple of runs :cussing


Now who can guess my next question...?




Jay
Super Administratorvw54
Super Administrator
Always Waiting 4 Friday
*********

Rank Avatar

No Avatar


Posts: 16723
Threads: 378
Registered: August 26th, 2002
Member Is Offline

Location: Sunny Sydney
Theme: UltimaBB Pro Blue ( Default )
Mood: Oval resto ongoing

posted on September 12th, 2003 at 08:32 AM


how do you get rid of the runs...



Member64Samba
Learner Dubber
*


Avatar


Posts: 12
Threads: 4
Registered: July 31st, 2003
Member Is Offline

Location: Watford, London, ENGLAND
Theme: UltimaBB Pro Blue ( Default )
Mood: Covered in old

posted on September 13th, 2003 at 02:54 AM


Quote:
Originally posted by vw54
how do you get rid of the runs...


Yes you guessed it mate.....




Jay
Memberfatboy
Wolfsburg Wizard
Disciple of Kol
***


No Avatar


Posts: 603
Threads: 48
Registered: November 1st, 2002
Member Is Offline

Location: Belgrave Victoria
Theme: UltimaBB Pro Blue ( Default )
Mood: Hungry!

posted on September 13th, 2003 at 12:43 PM


Stop Drinking ten pints of lager and going for a curry ? :D

[Edited on 13-9-2003 by fatboy]




" Captain Picard, why are there no Indians on the Enterprise ? Don't you need IT Support ? "


  Go To Top


Powered by GaiaBB, © 2011 The GaiaBB Group


[ Queries: 40 ] [ PHP: 15.5% - SQL: 84.5% ]