| [ Total Views: 1008 | Total Replies: 2 | Thread Id: 15426 ] |
|
|
 lil bug
Commited Dubber
Posts: 54
Threads: 15
Registered: October 28th, 2003
Member Is Offline
Location: Bonnet Bay, Sydney
Theme: UltimaBB Pro Blue ( Default )
Mood: slightly nutty
|
| posted on November 5th, 2003 at 09:17 PM |
|
|
Removing rear apron
To remove the rear apron is it better/easier to drillout the spot welds or get a chisel under and knock em off...?
Or is there a betta way...?
I don't know how to attack it... Help!
|
|
|
1303Steve
A.k.a.: Steve Carter
Scirocco Rare
Posts: 8636
Threads: 559
Registered: August 27th, 2002
Member Is Offline
Location: Sydney, NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: Parrot Heading
|
| posted on November 5th, 2003 at 10:13 PM |
|
|
Hi
Wire brush the area, then wave a bit of heat over the area from an oxy to highlight the welds, use special spot weld removing drill bits you can by
from engineers supply places. Avoid drilling right through into the metal you want to keep.
1302Steve
|
|
|
Stanley
Compulsive Aussie Vee Dubber
I guess the reward is in the doing of it
Posts: 4523
Threads: 270
Registered: March 13th, 2003
Member Is Offline
Location: Karalee...near Ipswich Qld
Theme: UltimaBB Psyche Grey
Mood: caught a bolt of lightning cursed the day I let it go
|
| posted on November 6th, 2003 at 06:28 AM |
|
|
There was a recent edition of VW Trends where the did a tech article on removeable rear aprons showed step by step how to do it.
|
|
|
wadd
Seriously Crusin Dubber
Posts: 179
Threads: 41
Registered: April 6th, 2003
Member Is Offline
Location: Mt Isa Qld
Theme: UltimaBB Pro Blue ( Default )
Mood: sunny
|
| posted on November 6th, 2003 at 09:04 AM |
|
|
i`ve just had a go at cold chiseling some spot welds ...and it can tear both sections if your not care full ..then tried drilling them out with a
normal drill bit had to drill right through ..holes in both pieces ..because some one said that you could not get spot weld drill bits .. hope that
helps ..get the right tool if you can 
|
|
|
lil bug
Commited Dubber
Posts: 54
Threads: 15
Registered: October 28th, 2003
Member Is Offline
Location: Bonnet Bay, Sydney
Theme: UltimaBB Pro Blue ( Default )
Mood: slightly nutty
|
| posted on November 6th, 2003 at 04:23 PM |
|
|
Sweet. I'll try an get a spot weld bit. Wonder if that VW Tends article is on the site???
|
|
|
