Posts: 199
Threads: 39
Registered: January 4th, 2003
Member Is Offline
Location: Coffs Harbour, NSW
Theme: UltimaBB Psyche Blue
Mood: Be cool.
posted on November 15th, 2003 at 10:18 PM
Fit motor to gearbox problems
I'm just up to putting a 1600 into my '71 Super Beetle 'S'.
Now I replaced the throw out bearing and replaced the sleeve that the bearing slides in and out of. The sleeve with the three bolts, with the oil seal
behind it.
Now my problem is, when I'm sliding the engine on to the splined shaft, it only goes within half an inch of mating with the tranny and then stops
and won't go any further. Is the throw out bearing sleeve (that's what I call it), interfering with the 'clutch ring' (that's
what I call it anyway), that the throw out bearing comes in touch with when the clutch is depressed? In other words, is the sleeve to long? Should I
cut about half an inch off the end of the throw out bearing sleeve? Or is my problem something else? I've been running the car for about 2 years
without the sleeve installed. I only put it back in when I replaced the throw out bearing, thinking it's in there for a reason. What that is, I
don't know. No other tranny setup has got them in. Does anyone have any ideas.
Regards,
Mark :thumb
Don't ever let anyone tell you, "It can't be done."
Andy
Son of Jim - Creator of Good
Andy's Adventures
Posts: 2819
Threads: 181
Registered: November 5th, 2002
Member Is Offline
Location: Brisbane
Theme: UltimaBB Pro Blue ( Default )
Mood: Happy Man
posted on November 15th, 2003 at 11:25 PM
Not really sure, but did you have the pressure plate off? If so did you align the friction plate properly when re-assembling?
Just a guess.
:thumb
helterskelter400
Fahrvergnugen
Posts: 900
Threads: 62
Registered: August 25th, 2002
Member Is Offline
Theme: UltimaBB Pro Grey
posted on November 15th, 2003 at 11:29 PM
is it what andy the bike boy said or it could be, as i found after much inning and outting, the splines not matching. doh.
turn the motor over a bit to see if it matched better.
dont know aboiut supers with sleeves on thrush bearings!
:thumb
duncombemu
A.k.a.: Mark Atkins
Seriously Crusin Dubber
Posts: 199
Threads: 39
Registered: January 4th, 2003
Member Is Offline
Location: Coffs Harbour, NSW
Theme: UltimaBB Psyche Blue
Mood: Be cool.
posted on November 16th, 2003 at 07:10 AM
No Andy, that was a different motor/setup.
I've got 4 Beetles that drive, with two that are registered. So that's probably how easy it can be, to get confused.
This engine has come out of an other Beetle and was running very well.
Any ideas?
Regards,
Mark:thumb
Don't ever let anyone tell you, "It can't be done."
posted on November 15th, 2003 at 10:18 PM
