Posts: 17
Threads: 5
Registered: November 8th, 2003
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
posted on December 8th, 2003 at 08:43 PM
Why use Magnetos?
Pardon my ignorance, but . . .
Why are magnetos so popular with so called 'hot' engines? What are their advantages and disadvantages?
They sure look the business though.
Just read Dave Beckers post in Readers Rides, and it sparked my question.
Ray65432
Learner Dubber
Posts: 14
Threads: 2
Registered: September 19th, 2003
Member Is Offline
Location: country Vic
Theme: UltimaBB Pro Blue ( Default )
posted on December 10th, 2003 at 07:13 PM
magnetoes
Basically, a coil ignition needs time to build up electricity for the spark which is done while the points are closed, therefore the faster the engine
is revving the less time is available to build up the spark for the next plug in line.
So, some people use twin point distributors (one set of points and one coil) for numbers one and three and the other set for two and four, therefore
increasing the dwell angle on each set of points and allowing twice as long for the spark to build up in the coil for each time it fires.
A magneto doesn't require this time to build up the spark; also a magneto at low revs has an impulse arrangment so that when it is spinning
slowly it uses the impulse to intensify the spark when the magneto is not spinning fast enough.
So, if you intend to run the motor at high revs and you require a better spark, a magneto will do the job.
Ray
Rossco
Learner Dubber
Posts: 17
Threads: 5
Registered: November 8th, 2003
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
posted on December 10th, 2003 at 09:42 PM
Ray,
Thanks for the concise explaination. The fog is starting to lift....
