Board Logo
Home Home  Frequently Asked Questions FAQ  View Topic Activity Topic Activity  Forum Stats Stats  Contact Us Contact Us  Banners Banners
Last active: Never Not logged in [ Log In - Register ]
Aussieveedubbers Navigation Symbol Paint and Body Navigation Symbol floor pan beetle Go To Bottom

Printable Version  
[ Total Views: 755 | Total Replies: -2 | Thread Id: 20485 ]
« View Previous Thread View Next Thread »
Author: Subject: floor pan beetle
Membernicko
Officially Full-On Dubber
***

Avatar


Posts: 389
Threads: 77
Registered: March 18th, 2003
Member Is Offline

Location: Mid North Coast(Blackhead)
Theme: UltimaBB Pro Blue ( Default )
Mood: Tired

posted on March 16th, 2004 at 06:41 PM
floor pan beetle

I am trying to weld a new floor pan into a beetle chassis (body off) and are experiencing difficulties along the tunnel edge of the pan. I am using an oxy set with an 8 mm tip. There is about 1mm gap between the edge of the pan and where the tunnel folds up. The edge of the pan burns away before the lip gets hot enough to be molten probably becsue it is thicker steel than the pan. Any suggestions? I know a mig welder would makke it easier but I dont have one of these and beleive it should be able to be done with an oxy
Cheers Nicko


 Aussieveedubbers Navigation Symbol Paint and Body Navigation Symbol floor pan beetle   Go To Top


Powered by GaiaBB, © 2011 The GaiaBB Group
(C) 2001-2024 Aussieveedubbers

[ Queries: 40 ] [ PHP: 10.0% - SQL: 90.0% ]