Posts: 370
Threads: 71
Registered: August 28th, 2002
Member Is Offline
Location: Geelong
Theme: UltimaBB Pro Blue ( Default )
Mood: Low
posted on August 13th, 2004 at 02:04 PM
Air cleaner assembly?
Ok, the air cleaners that I got for the dual webers have a long threaded rod, a nut, 2 lock washers, a rubber/metal concave washer and a wing nut for
each side of the air cleaner (ie 2 sets for each cleaner).
Everything is pretty easy to work out where it all goes, just the nut and a lock washer. Do these go high on the threaded rod, to hold the concave
washer to the underside of the air cleaner top?, if so how do I set this height - is it just trial & error until it is tight?
All help is much appreciated by this complete novice who dreams of a working dual carb engine.:thumb
BiX
Veteran Volks Folk
Posts: 2499
Threads: 154
Registered: September 2nd, 2002
Member Is Offline
Location: Brisbane
Theme: UltimaBB Pro Blue ( Default )
posted on August 13th, 2004 at 03:20 PM
nope use the nut and lock washer to lock the rod into the base of teh air cleaner. eg screw the rod in the lock it off with the nut and washer and use
the concave washers ontop of the top piece under the wing nut.
I have no sympathy for my car, only the wallet that pays for it!
Go hard or go home!!!!
Kafer Lover
Officially Full-On Dubber
Posts: 370
Threads: 71
Registered: August 28th, 2002
Member Is Offline
Location: Geelong
Theme: UltimaBB Pro Blue ( Default )
Mood: Low
