| [ Total Views: 396 | Total Replies: 1 | Thread Id: 27450 ] |
|
|
 low55
Seriously Crusin Dubber
Posts: 173
Threads: 33
Registered: August 26th, 2003
Member Is Offline
Location: narre warren victoria
Theme: UltimaBB Pro Blue ( Default )
Mood: arr what
|
| posted on August 16th, 2004 at 08:22 PM |
|
|
what size valves
hi all the next stage of my rebuild is the heads hers the list
of what ive got so far
as 41 cases
balanced alloy degree wheel
balanced lightend fly wheel
balanced crank and rods
balanced 85.5 pistons and barrels
009 dizzy
cam 392 degree 400 tho of lift
cases savers
and ive got a set of near new 040 heads
so my question is what valve size and comp
any help would be grate thanks
travis
[Edited on 16-8-2004 by low55]
i thirt of some thing funny and stupid to write here then i forgot it
|
|
|
seagull
Compulsive Aussie Vee Dubber
Posts: 4979
Threads: 752
Registered: December 25th, 2003
Member Is Offline
Location: PerthWA
Theme: UltimaBB Pro Blue ( Default )
|
| posted on August 16th, 2004 at 09:38 PM |
|
|
I would not play with it , see how it goes you can all ways pull them off later .
Looking for that special lady : PM me for coffee & cake
|
|
|
boof2332
Custom Title Time!
Posts: 1210
Threads: 120
Registered: May 10th, 2004
Member Is Offline
Location: Beecroft Sydney
Theme: UltimaBB Pro Blue ( Default )
Mood: Sympathetic
|
| posted on August 17th, 2004 at 12:17 AM |
|
|
What carbs are you running????
I would just do a little port work to improve the flow of the intake and exhaust.....go to http://www.cal-look.com and see there article...do a search as there are plenty of others.
A nice merged exhaust..not thunderbird type.
Depending on the carbs or carb you pick, with the balancing and 009 dizzy should give a nice little power increase.
Good luck,
Matt
|
|
|
70AutoStik
Insano Dub Head
Posts: 730
Threads: 18
Registered: August 30th, 2002
Member Is Offline
Location: Dandenong. Victoria
Theme: UltimaBB Pro Blue ( Default )
|
| posted on August 26th, 2004 at 01:39 AM |
|
|
392 degree cam? I think you might have mistyped there...
Stick with the stock valve size with an 85.5mm bore as any larger will just cause problems with shrouding, needing some bloody expensive redesigning
of the combustion chamber or a ridiculous amount of lift just to get back to stock flow figures.
Compression Ratio depends a lot on what cam you are running, which determines where your engine will be making power, what fuel and how much other
work is done to your heads. A figure of 8.0 for a pump fueled egine is a good ballpark (premium if standard combustion chambers, standard if reshaped
and polished.)
|
|
|
