Posts: 107
Threads: 28
Registered: May 11th, 2005
Member Is Offline
Location: Tennessee, USA
Theme: UltimaBB Pro Blue ( Default )
posted on May 15th, 2005 at 04:34 AM
General questions EJ20T
I have several questions regarding a Ej20T convesrion.
1. Why are some EJ20T conversions moving their transmission forward 2"?
2. If people are getting JDM EJ20T engines where are they getting the electrical fitting for the engine?
3. Is everyone using and aftermarket engine management system?
4. Does anyone have dimension on a EJ20T L, W, H, and from the center of the crank to the top of intercooler or bottom of oil pan?
Sorry for all the questions. Any help would be appreciated.
gayanne
Officially Full-On Dubber
Posts: 307
Threads: 3
Registered: May 10th, 2004
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
Mood: Pure Tubular Adrenalin Subie Power
posted on May 15th, 2005 at 12:08 PM
Hi flat_iv, Q1 Weight transfer more over wheels (better balance due to motor being a little heavier) Q2 Iva from half cuts or wiring looms supplied
from after market Computers. Q3 Most of us are to get more optium performance. Q4 To answer this ques. if putting in early beetle you will need to do
some cutting even moving motor forward 2inch.For late model beetle check Jak Rizzos late model road going EJ20t version beelte on this forum, this
will give more insight of whats needed.JVLRacing
