| [ Total Views: 937 | Total Replies: 4 | Thread Id: 41035 ] |
|
|
 AdrianH
Officially Full-On Dubber
Posts: 257
Threads: 20
Registered: March 5th, 2004
Member Is Offline
Location: New Zealand
Theme: UltimaBB Pro Blue ( Default )
Mood: rebuilding again
|
| posted on June 29th, 2005 at 08:28 PM |
|
|
Cylinder shims ??
Does anyone grind cylinder shims over there ? I have tried locally, but cant seem to get anyone to do them right. The last .060" bugpack ones I got
were .006" difference between the thickest and thinnest.
Im prepared to pay for good work !!
|
|
|
1303Steve
A.k.a.: Steve Carter
Scirocco Rare
Posts: 8650
Threads: 564
Registered: August 27th, 2002
Member Is Offline
Location: Sydney, NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: Parrot Heading
|
| posted on June 29th, 2005 at 08:37 PM |
|
|
Hi
What size bore?
Steve
|
|
|
AdrianH
Officially Full-On Dubber
Posts: 257
Threads: 20
Registered: March 5th, 2004
Member Is Offline
Location: New Zealand
Theme: UltimaBB Pro Blue ( Default )
Mood: rebuilding again
|
| posted on June 30th, 2005 at 05:14 AM |
|
|
94 and 90.5mm. I would like .065" in the 90.5 and yet to confirm the 94s...
|
|
|
56astro
Custom Title Time!
Posts: 1772
Threads: 74
Registered: August 25th, 2002
Member Is Offline
Location: The Nambucca
Theme: UltimaBB Pro Blue ( Default )
Mood: Pobjoy Powered with twin ignition & soon to be EFI'd
|
| posted on June 30th, 2005 at 10:01 AM |
|
|
Call Stan (or Ruth) Pobjoy, near Coffs Harbour - 02 6654 3694
Arguably the best in the land.
VW car, VW engine ...... keepin it "real"
35MPG on 101.3kPa |
|
|
2443TT
A.k.a.: Ian
Fahrvergnugen
Posts: 962
Threads: 69
Registered: December 11th, 2002
Member Is Offline
Location: Cairns
Theme: UltimaBB Pro Blue ( Default )
|
| posted on July 8th, 2005 at 02:34 PM |
|
|
I got my spacers from cb performance. 0.230" ones, and the 0.030" shims came from there too. All my deck heights came up to within 0.002" of each
other which is acceptable. about 0.04 variation as far as the CR calculations go...
|
|
|
.JPG "Avatar")
