 |
Aussieveedubbers  Paint and Body Jackpoint/Lift Channel fixing |
|
 |
|
|
|
| [ Total Views: 551 | Total Replies: 1 | Thread Id: 44452 ] |
|
|
 ctefeh
Wolfsburg Wizard
Posts: 479
Threads: 30
Registered: April 23rd, 2005
Member Is Offline
Location: SiddaKnee nowadayz
Theme: UltimaBB Pro Blue ( Default )
Mood: grimly determined
|
 posted on October 4th, 2005 at 12:12 PM |
|
|
Jackpoint/Lift Channel fixing
All,
The jackpoints on my wifes Beetle have ridden up over the years it seems. I can cut the jackpoints off the pan and chassis, but the question is
:
Is the "support panel" separate from the heater channel, and could I fab/weld up a new section of it so the jackpoints are level once again?
I figure the running boards will have a fixing/replacing session as well as the ends of the jackpoints have crushed these a little as well....
Thanks in advance
Ctefeh
|
|
|
ctefeh
Wolfsburg Wizard
Posts: 479
Threads: 30
Registered: April 23rd, 2005
Member Is Offline
Location: SiddaKnee nowadayz
Theme: UltimaBB Pro Blue ( Default )
Mood: grimly determined
|
| posted on October 6th, 2005 at 10:24 AM |
|
|
Errrrr........no-one has ever fixed a jackpoint or the support plate??? Am I going to wield gas-axe, cutoff wheel and Mig blindly?:duh
I'll check later when I'm back from travelling......
|
|
|
|
|
| Aussieveedubbers Paint and Body Jackpoint/Lift Channel fixing |
|
 |
|
|
Powered by GaiaBB, © 2011 The GaiaBB Group
(C) 2001-2024 Aussieveedubbers
[ Queries: 40 ]
[ PHP: 11.7% - SQL: 88.3% ]
|
|
|
