| [ Total Views: 554 | Total Replies: 2 | Thread Id: 6306 ] |
|
|
 Andy42
Insano Dub Head
Posts: 709
Threads: 47
Registered: March 13th, 2003
Member Is Offline
Location: Airlie Beach
Theme: UltimaBB Pro Blue ( Default )
Mood: 2.5t Subi Powered
|
| posted on May 12th, 2003 at 06:47 PM |
|
|
End float???
How much end float is acceptable in a type 4 crank(1800). |
|
|
KruizinKombi
A.k.a.: Col
Bishop of Volkswagenism
Seriously Obsessed Cyber Dubber
Posts: 3493
Threads: 104
Registered: August 25th, 2002
Member Is Offline
Location: Gippsland, Victoria
Theme: UltimaBB Pro Blue ( Default )
Mood: Indifferent
|
| posted on May 12th, 2003 at 06:55 PM |
|
|
0.07-0.13mm (0.0027-0.005 in) taken at No. 1 bearing.
Kruizin Kol
|
|
|
KruizinKombi
A.k.a.: Col
Bishop of Volkswagenism
Seriously Obsessed Cyber Dubber
Posts: 3493
Threads: 104
Registered: August 25th, 2002
Member Is Offline
Location: Gippsland, Victoria
Theme: UltimaBB Pro Blue ( Default )
Mood: Indifferent
|
| posted on May 12th, 2003 at 06:56 PM |
|
|
Oops, wear limit is 0.15mm (6 thou). 
Kruizin Kol
|
|
|
Andy42
Insano Dub Head
Posts: 709
Threads: 47
Registered: March 13th, 2003
Member Is Offline
Location: Airlie Beach
Theme: UltimaBB Pro Blue ( Default )
Mood: 2.5t Subi Powered
|
| posted on May 12th, 2003 at 06:58 PM |
|
|
OH so if I can move the crank back and forward about three mm that must be ..... well....stuffed |
|
|
KruizinKombi
A.k.a.: Col
Bishop of Volkswagenism
Seriously Obsessed Cyber Dubber
Posts: 3493
Threads: 104
Registered: August 25th, 2002
Member Is Offline
Location: Gippsland, Victoria
Theme: UltimaBB Pro Blue ( Default )
Mood: Indifferent
|
| posted on May 12th, 2003 at 07:05 PM |
|
|
Ah.... yeah :o
I've never been in that situation, but maybe some bearings might help?
Kruizin Kol
|
|
|
 vw54
Super Administrator
Always Waiting 4 Friday
Posts: 16723
Threads: 378
Registered: August 26th, 2002
Member Is Offline
Location: Sunny Sydney
Theme: UltimaBB Pro Blue ( Default )
Mood: Oval resto ongoing
|
| posted on May 12th, 2003 at 08:20 PM |
|
|
I would say that the case will need maching as well.
but more than likely its stuffed altogether as the thrust surface on the number one bearing will be gone.
|
|
|
