| [ Total Views: 1719 | Total Replies: 17 | Thread Id: 64598 ] |
|
|
 Volksaddict
Wolfsburg Wizard
Posts: 533
Threads: 102
Registered: December 25th, 2004
Member Is Offline
Location: Sawtell Mid North NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: hooked
|
| posted on August 26th, 2007 at 04:41 PM |
|
|
T3 Running Poorly
My 2.1 watercooled is playing up ...reading the Bentleys theres lots of resistance checks to do ...just hoping someone has had the same problem!!!
It starts fine but has a flat spot on take off ,which then sends the idle to 2000rpm and has no power ...trying to clear it will cause
backfiring/popping thru the intake.persistence will clear it and top end is fine ..until you slow down or change back a gear!!!
Thanks in advance to any helpers
Cheers&Beers
Ray V
|
|
|
greedy53
Bishop of Volkswagenism
Posts: 3062
Threads: 468
Registered: March 4th, 2006
Member Is Offline
Location: camden nsw 2570
Theme: UltimaBB Pro Grey
Mood: strung out
|
| posted on August 26th, 2007 at 08:20 PM |
|
|
1 check that both fuel filters are good
2 the charcole canister may be stuffed
3 check the 5th injector is working
and also the computer cold start is ok
good luck
|
|
|
Volksaddict
Wolfsburg Wizard
Posts: 533
Threads: 102
Registered: December 25th, 2004
Member Is Offline
Location: Sawtell Mid North NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: hooked
|
| posted on August 26th, 2007 at 10:23 PM |
|
|
Thanks for the advice Greedy53
Cheers&Beers
Ray V
|
|
|
syncro
Seriously Crusin Dubber
Posts: 103
Threads: 27
Registered: August 30th, 2002
Member Is Offline
Location: melbourne
Theme: UltimaBB Pro Blue ( Default )
Mood: spacey
|
| posted on August 27th, 2007 at 08:06 AM |
|
|
rough running
Hey there,
here's my suggestions, I've been through the rough running a few times with my Syncro, check the micro switch on the throttle body is switching,
with the engine off move the throttle butterfly slowly off idle, you should be able to here it 'click' if not it may need adjusting / replacing,
they can get corroded and stop working, todays lesson will be Bently 24.35.
If that doesn't fix it replace the Temp 2 sensor, just replaced mine, made a surprising difference, really smoothed out cold starts + general
running.
Oxy sensor can also can make quite a difference. both the Oxy and Temp2 tend to go out of range gradually rather than just outright fail.
Steve. |
|
|
Volksaddict
Wolfsburg Wizard
Posts: 533
Threads: 102
Registered: December 25th, 2004
Member Is Offline
Location: Sawtell Mid North NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: hooked
|
| posted on August 27th, 2007 at 09:48 PM |
|
|
Thanks Steve ..will let you know how i go ..lucky ive got a 'backup' beetle at the moment!!!!
Cheers&Beers
Ray V
|
|
|
Iwish4aSynchro
Wolfsburg Wizard
Posts: 639
Threads: 102
Registered: August 7th, 2006
Member Is Offline
Location: Maclean NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: Cheery
|
| posted on August 28th, 2007 at 10:12 PM |
|
|
It's in the throttle body or rather the small switch which controls fuel.
I would gather it is set too far retarted.
Firstly drop fuel pump and remove rust from pump...
Correctly re attach wires and then. Adjust small allan/Hex(4mm?) key throttle fuel on/off switch on bottom of throttle body;
if u have seen it you will know what i am talking about.
Keep the steering and the propulsion seperate . Still a Kombi...
It's all good, until it's bad, i suppose
|
|
|
Volksaddict
Wolfsburg Wizard
Posts: 533
Threads: 102
Registered: December 25th, 2004
Member Is Offline
Location: Sawtell Mid North NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: hooked
|
| posted on August 30th, 2007 at 06:02 PM |
|
|
Hey ...iwish 4 a syncro ..ill try that on the weekend ..let you know how i go ..thanks for the help
Cheers&Beers
Ray V
|
|
|
syncro
Seriously Crusin Dubber
Posts: 103
Threads: 27
Registered: August 30th, 2002
Member Is Offline
Location: melbourne
Theme: UltimaBB Pro Blue ( Default )
Mood: spacey
|
| posted on August 31st, 2007 at 07:52 AM |
|
|
Digipants Pro.
If you haven't already seen it, there is a dealer manual called " Digifant pro training manual" which contains VW factory info and basic
explanation of the system and how to fix and adjust.http://members.verizon.net/blumax/protrainingdigifantvanagon.htm this is the first link that google spat out there is also a
site that you can down load a zipped version, if you have a look.
good luck with it,
Steve. |
|
|
Volksaddict
Wolfsburg Wizard
Posts: 533
Threads: 102
Registered: December 25th, 2004
Member Is Offline
Location: Sawtell Mid North NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: hooked
|
| posted on September 1st, 2007 at 06:00 PM |
|
|
Digipants Pro ...its very good ...thanks for the lead steve ...ive bookmarked it..no success yet ...found the airfilter trap full of water ...good
washable airfilter which looks like its stopped it???..no clicking at the throttle , and the resistance is wrong 0.06 at idle position with no change
thru range to full throttle ...so needs further investigation,,,after i try adjusting the the throttle switch...
Also got a strange humming noise coming from the rear cab vents (dualcab) ..wondering if that has something to do with fuel tank/charcoal cannister
Thanks for any help!!
Cheers&Beers
Ray V
|
|
|
Iwish4aSynchro
Wolfsburg Wizard
Posts: 639
Threads: 102
Registered: August 7th, 2006
Member Is Offline
Location: Maclean NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: Cheery
|
| posted on September 15th, 2007 at 11:54 AM |
|
|
How goes?
Any progress???
Interesting link syncro; actually a little more elaborating than the Bentley.
Hang on it is the Bentley manual.
[ Edited on 15-9-2007 by Iwish4aSynchro ]
Keep the steering and the propulsion seperate . Still a Kombi...
It's all good, until it's bad, i suppose
|
|
|
Volksaddict
Wolfsburg Wizard
Posts: 533
Threads: 102
Registered: December 25th, 2004
Member Is Offline
Location: Sawtell Mid North NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: hooked
|
| posted on September 16th, 2007 at 12:05 PM |
|
|
Sorted ...thanks to luke pell ..who had a throttle body assembly which i borrowed to try...all good now ...will replace the oxygen sensor and am
looking for a 'go fast chip' for the puter...anyone have any clues where to get these???
Thanks to all for your advice
Cheers&Beers
Ray V
|
|
|
greedy53
Bishop of Volkswagenism
Posts: 3062
Threads: 468
Registered: March 4th, 2006
Member Is Offline
Location: camden nsw 2570
Theme: UltimaBB Pro Grey
Mood: strung out
|
| posted on September 16th, 2007 at 02:35 PM |
|
|
vintage vw at campsi nsw
they sponser this site you will find them here
|
|
|
Volksaddict
Wolfsburg Wizard
Posts: 533
Threads: 102
Registered: December 25th, 2004
Member Is Offline
Location: Sawtell Mid North NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: hooked
|
| posted on September 16th, 2007 at 09:27 PM |
|
|
Thanks Greedy!!!
Cheers&Beers
Ray V
|
|
|
Iwish4aSynchro
Wolfsburg Wizard
Posts: 639
Threads: 102
Registered: August 7th, 2006
Member Is Offline
Location: Maclean NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: Cheery
|
| posted on September 17th, 2007 at 10:19 PM |
|
|
New throttle body??
Keep the steering and the propulsion seperate . Still a Kombi...
It's all good, until it's bad, i suppose
|
|
|
Volksaddict
Wolfsburg Wizard
Posts: 533
Threads: 102
Registered: December 25th, 2004
Member Is Offline
Location: Sawtell Mid North NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: hooked
|
| posted on September 18th, 2007 at 07:49 PM |
|
|
Yep ...new throttle body.....changed the wheels while it was off the road to merc alloys ...mustve forgot to tighten the pass front ...lost it on the
test run ..scary stuff ...need to fit longer studs ..any clues on where to get these???
Cheers&Beers
Ray V
|
|
|
pod
A.k.a.: paul mrvw061
Compulsive Aussie Vee Dubber
i`ve got to finish this thing one day
Posts: 4980
Threads: 145
Registered: December 28th, 2003
Member Is Offline
Location: campbelltown,nsw
Theme: UltimaBB Pro Yellow
Mood: could be better
|
| posted on September 18th, 2007 at 07:52 PM |
|
|
i got mine from frank tonittos at silverdale ,but most tyre places should be able to get them for you:thumb
|
|
|
Iwish4aSynchro
Wolfsburg Wizard
Posts: 639
Threads: 102
Registered: August 7th, 2006
Member Is Offline
Location: Maclean NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: Cheery
|
| posted on September 20th, 2007 at 09:15 PM |
|
|
Ok i am doing the same thing at present wheel studs that is.
As the Merc rims i have see post.
http://forums.aussieveedubbers.com/viewtopic.php?tid=65063
Oh yeh how much was "new" throttle body. U2U $$ if u like.
i am dealing with the slight jutter or surge at low RPM in 3rd to 4th gear just going through town at 55ks in 4th that kinda thing.
[ Edited on 20-9-2007 by Iwish4aSynchro ]
Keep the steering and the propulsion seperate . Still a Kombi...
It's all good, until it's bad, i suppose
|
|
|
Iwish4aSynchro
Wolfsburg Wizard
Posts: 639
Threads: 102
Registered: August 7th, 2006
Member Is Offline
Location: Maclean NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: Cheery
|
| posted on September 20th, 2007 at 09:28 PM |
|
|
| Quote: | Originally
posted by Volksaddict
Yep ...new throttle body.....changed the wheels while it was off the road to merc alloys ...mustve forgot to tighten the pass front ...lost it on the
test run ..scary stuff ...need to fit longer studs ..any clues on where to get these???
|
I suppose in all the excitement it's easy to do. not that i have done it but i am sure many have.
Hoefully the rims are still all good.
Me i always have the thought i hope i done them all up tight enough as i drive of down the road.
Keep the steering and the propulsion seperate . Still a Kombi...
It's all good, until it's bad, i suppose
|
|
|
