Board Logo
Go To Bottom

Printable Version  
[ Total Views: 13624 | Total Replies: 61 | Thread Id: 68078 ]
 Pages:  1  2  3
Author: Subject:  HOW TO: shift rod bushing replacement
MemberSTIDUB
Custom Title Time!
Over it.
*****


Avatar


Posts: 1497
Threads: 57
Registered: June 23rd, 2008
Member Is Offline

Location: Where else but QLD :)
Theme: UltimaBB Pro Blue
Mood: Worn out, for no benefit.

posted on May 10th, 2011 at 11:06 PM



dude, i could kiss you! ok not quite that but close, but you know the best bit, i get to take it back out & shorten it! yaaaayyY!!!!!!!!!!!!!!!!! NOT.



Volkswagen Drivers Club of Queensland - member :)

STIDUB - yep its still a work in progress

Vwdcq club car racing/ and crashing while my bug isn't finished.

The above are personal views, no more, no less
Memberbnicho
A.k.a.: Brett Nicholson
Wolfsburg Wizard
***


Avatar


Posts: 436
Threads: 55
Registered: February 24th, 2009
Member Is Offline

Location: Melbourne, Australia
Theme: UltimaBB Pro Blue ( Default )
Mood: Usually Cranky!

posted on July 12th, 2012 at 01:33 PM



I did this job this morning. Thanks to this guide it was all very easy and only took about 90 minutes including a coffee break.

I did not use any string or wire, instead I used a boroscope down the tunnel from the rear end (stop sniggering you!) to track the progress of the rod back through the tunnel. It didn't hang up on anything because I could see what to avoid. I also found a million spider-webs in the tunnel and a worn out bush from a previous replacement, before I owned the car.

The shift is soo much nicer now. :)




Brett Nicholson
Melbourne, Victoria
1974 VW Superbug L - Olive :cool:
1971 Morris Mini Moke - Mopoke
1966 Austin Mini - Audrey
1965 Morris Mini Traveller - Trixie
2007 Land Rover Freelander 2
2009 Nissan Pathfinder
 Pages:  1  2  3


  Go To Top


Powered by GaiaBB, © 2011 The GaiaBB Group
(C) 2001-2024 Aussieveedubbers

[ Queries: 40 ] [ PHP: 8.3% - SQL: 91.7% ]