Posts: 591
Threads: 108
Registered: August 25th, 2002
Member Is Offline
Location: lismore nsw
Theme: UltimaBB Pro Blue ( Default )
posted on September 20th, 2002 at 09:12 PM
1700 type 4 heads?
I seem to remeber someone saying that the early 1700 heads were not very good
is this true and why?
Because ive got an 1800 engine without heads and a complete 1700 so I thought about pulling the heads of and fitting to the 1800
marcel:thumb
Phil74Camper
Son of Jim - Creator of Good
Head in the Clouds
Posts: 2703
Threads: 193
Registered: August 28th, 2002
Member Is Offline
Location: Sydney
Theme: UltimaBB Pro Blue ( Default )
posted on September 23rd, 2002 at 02:32 PM
Well the valves on a 1700 head are slightly smaller than on an 1800 head, but not as small as they are on a 2-litre head. Not enough to worry
about.
Theoretically your 1800 cylinders should fit into the 1700 head too, but check first.
All these old Type 4 heads have a weakness in the valve seats, which have a tendency to drop out. You may have that problem with an old set of 1700s.
The fix is to either buy new heads (only 2-litre heads are available new) or have your old heads re-seated. Fractionally larger seats are used and
high-pressure fitted to stop them dropping out later.