| [ Total Views: 981 | Total Replies: 15 | Thread Id: 91445 ] |
|
|
 Super1302
Officially Full-On Dubber
Posts: 361
Threads: 76
Registered: July 31st, 2008
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on July 7th, 2011 at 05:08 PM |
|
|
Starter or Engine
well my engine will not turn over well with the starter.
the engine will turn over with the spanner on the crank shaft easily enough. good compression too.
but to no avail the starter will not have enough grunt to turn it.
result is a slight turn a click or nothing at all.
anyone!
we have changed starters and the wiring is good.
do you think maybe both starters are shot.
going nuts here
Paul
|
|
|
 Yogie
Super Moderator
Posts: 1603
Threads: 108
Registered: June 7th, 2003
Member Is Offline
Location: Brisbane
Theme: UltimaBB Pro Blue
|
| posted on July 7th, 2011 at 05:32 PM |
|
|
Does your battery have enough charge to turn it over?
Yogie
|
|
|
Super1302
Officially Full-On Dubber
Posts: 361
Threads: 76
Registered: July 31st, 2008
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on July 7th, 2011 at 05:41 PM |
|
|
new with 12.8v and 540cca
|
|
|
68AutoBug
A.k.a.: Lee Noonan
Aircooled Master
Beetle Restorer - Experience over 138% - YIKES --
Posts: 11654
Threads: 449
Registered: August 31st, 2002
Member Is Offline
Location: SCONE in UPPER HUNTER VALLEY NSW
Theme: UltimaBB Pro Yellow
Mood: Really Mentally Ill - all of the time -
|
 posted on July 7th, 2011 at 05:52 PM |
|
|
Hi Paul
to check whether the starter solenoid is NOT working
with the car in neutral and the RH rear jacked up
place a large screwdriver across the terminals of the Solenoid on the starter motor...
One will have a large cable going to it...
there are two large nuts and threads...
place the screwdriver across those..
and if the solenoid isn't working BUT the starter motor is OK
it will turn over...
there will be SPARKS... lol
the other common problem with cars over 40 years old...
the contacts in the starter switches are dirty or contaminated and don't let enough power to throw the solenoid in
which then turns on the starter motor...
I would guess first off..
the ignition switch...
there is a small wire coming off the solenoid....
replace it with another wire and push one end thru the hole in the floor into the battery compartment,
and the other end onto the terminal where the small wire went..
then touch the other end of that wire onto the + positive side of the battery..
and if the solenoid is OK then the starter will turn once the solenoid clicks in....
I hope you can understand all that...
Lee
- [size=4]Helping keep Air Cooled VWs on the road - location: SCONE in the Upper Hunter Valley - Northern NSW 320 kms NNW of SYDNEY--- [/size]
|
|
|
68AutoBug
A.k.a.: Lee Noonan
Aircooled Master
Beetle Restorer - Experience over 138% - YIKES --
Posts: 11654
Threads: 449
Registered: August 31st, 2002
Member Is Offline
Location: SCONE in UPPER HUNTER VALLEY NSW
Theme: UltimaBB Pro Yellow
Mood: Really Mentally Ill - all of the time -
|
| posted on July 7th, 2011 at 05:53 PM |
|
|
| Quote: | Originally
posted by Super1302
new with 12.8v and 540cca
|
12.8v and 540cca is good..
Lee
- [size=4]Helping keep Air Cooled VWs on the road - location: SCONE in the Upper Hunter Valley - Northern NSW 320 kms NNW of SYDNEY--- [/size]
|
|
|
Super1302
Officially Full-On Dubber
Posts: 361
Threads: 76
Registered: July 31st, 2008
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on July 7th, 2011 at 06:09 PM |
|
|
got that, hmmm, will give it a go or......... it will give me an up and go
|
|
|
68AutoBug
A.k.a.: Lee Noonan
Aircooled Master
Beetle Restorer - Experience over 138% - YIKES --
Posts: 11654
Threads: 449
Registered: August 31st, 2002
Member Is Offline
Location: SCONE in UPPER HUNTER VALLEY NSW
Theme: UltimaBB Pro Yellow
Mood: Really Mentally Ill - all of the time -
|
| posted on July 8th, 2011 at 01:24 PM |
|
|
I hope One of those works for You
it usually isn't the starter motor itself
LEE
- [size=4]Helping keep Air Cooled VWs on the road - location: SCONE in the Upper Hunter Valley - Northern NSW 320 kms NNW of SYDNEY--- [/size]
|
|
|
BiX
Veteran Volks Folk
Posts: 2499
Threads: 154
Registered: September 2nd, 2002
Member Is Offline
Location: Brisbane
Theme: UltimaBB Pro Blue ( Default )
|
| posted on July 8th, 2011 at 07:27 PM |
|
|
what autobug said.
I went through starting my car screw driver for about 2 months becuase I was to lazy to get a new solenoid.
Also put a new switch in which helped.
Check with the screw driver, then work your way back up the system.
I have no sympathy for my car, only the wallet that pays for it!
Go hard or go home!!!!
|
|
|
grumble
Son of Jim - Creator of Good
Posts: 2668
Threads: 53
Registered: June 10th, 2008
Member Is Offline
Location: Taree
Theme: UltimaBB Pro Blue ( Default )
Mood: happy all the time
|
| posted on July 8th, 2011 at 08:08 PM |
|
|
| Quote: | Originally
posted by 68AutoBug
Hi Paul
to check whether the starter solenoid is NOT working
with the car in neutral and the RH rear jacked up
place a large screwdriver across the terminals of the Solenoid on the starter motor...
One will have a large cable going to it...
there are two large nuts and threads...
place the screwdriver across those..
and if the solenoid isn't working BUT the starter motor is OK
it will turn over...
there will be SPARKS... lol
the other common problem with cars over 40 years old...
the contacts in the starter switches are dirty or contaminated and don't let enough power to throw the solenoid in
which then turns on the starter motor...
I would guess first off..
the ignition switch...
there is a small wire coming off the solenoid....
replace it with another wire and push one end thru the hole in the floor into the battery compartment,
and the other end onto the terminal where the small wire went..
then touch the other end of that wire onto the + positive side of the battery..
and if the solenoid is OK then the starter will turn once the solenoid clicks in....
I hope you can understand all that...
Lee
|
Please don't put the screwdriver across the main terminals as it will blow a chunk out of the screwdriver,use the other method involving the positive
cable and the solenoid cable,this will tell you if the solenoid is working and also the starter.Check the solenoid wire under the rear seat as
sometimes this will work its way apart or have a bad connection.If none of this works put a test light on the solenoid wire at the starter and operate
the starter,if the light doesn't light it should be the ignition switch contacts.
|
|
|
68AutoBug
A.k.a.: Lee Noonan
Aircooled Master
Beetle Restorer - Experience over 138% - YIKES --
Posts: 11654
Threads: 449
Registered: August 31st, 2002
Member Is Offline
Location: SCONE in UPPER HUNTER VALLEY NSW
Theme: UltimaBB Pro Yellow
Mood: Really Mentally Ill - all of the time -
|
 posted on July 8th, 2011 at 11:51 PM |
|
|
What happened to that screwdriver????
Hi
My 68 Beetle is a semi auto that Can;t be started when in Gear
When I first got it on the road..
I had to jack it up at a servo and use the screwdriver to start it
then at a Car show... lol..
[ waited until nearly everyone was gone.. lol ]
and parked on the road a few times and again ..
VW Jack and the big screwdriver
this was starting the engine... in gear... Hand Brake on....
and up on a VW jack.... lol
Not good on soft tar or grass.... lol
and I saw a Large screwdriver today with the end unusable...
I now think I remember what happened to it.... 
LEE
- [size=4]Helping keep Air Cooled VWs on the road - location: SCONE in the Upper Hunter Valley - Northern NSW 320 kms NNW of SYDNEY--- [/size]
|
|
|
ratty 63
A.k.a.: Rossco
Custom Title Time!
Posts: 1083
Threads: 74
Registered: October 1st, 2003
Member Is Offline
Location: Gold Coast, Qld
Theme: UltimaBB Pro Blue ( Default )
Mood: Just cured my shed envy! 
|
| posted on July 9th, 2011 at 11:12 AM |
|
|
I had the same problem with my '63 Beetle, which is still 6 volt and therefore prone to hard start problems.
I reconditioned two different starters and both of them acted the same way (I recoed the second one when the first didn't work, figuring that there
was a problem with the windings in the first one...)
I then replaced the starter bush in the bell housing/gearbox - starts better than ever.
Try this next - the bushes are cheap, and not all that difficult to replace - even with then engine in the car.
R 
|
|
|
MickH
A.k.a.: Michael Hutchinson
Bishop of Volkswagenism
Hairy Gutted Sloth
Posts: 3389
Threads: 29
Registered: September 6th, 2003
Member Is Offline
Location: TownsvilleTropical North QLD
Theme: UltimaBB Pro Blue ( Default )
Mood: Grow a brain...walls don't hit back...
|
| posted on July 9th, 2011 at 11:19 AM |
|
|
Dont forget to check your EARTH strap.....
tssnq.com.au
|
|
|
Bizarre
Super Moderator
The artist formerly known as blue74l
Posts: 12757
Threads: 732
Registered: August 25th, 2002
Member Is Offline
Location: Abbotsford, Sydney
Theme: UltimaBB Pro Blue ( Default )
|
| posted on July 9th, 2011 at 11:42 AM |
|
|
Yeah - I had the bushing this as well
I solved it by putting a "hi torque" starter in.
They dont need tohe bushing
(sounds great as well  )
Futue te ipsum!!!
|
|
|
ratty 63
A.k.a.: Rossco
Custom Title Time!
Posts: 1083
Threads: 74
Registered: October 1st, 2003
Member Is Offline
Location: Gold Coast, Qld
Theme: UltimaBB Pro Blue ( Default )
Mood: Just cured my shed envy!
|
| posted on July 10th, 2011 at 10:42 AM |
|
|
the Hi-torque starters do sound great and do an awesome job of starting higher compression engines...but compared to the cost of a replacement
bush....
R
|
|
|
Super1302
Officially Full-On Dubber
Posts: 361
Threads: 76
Registered: July 31st, 2008
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on July 19th, 2011 at 07:59 PM |
|
|
was the bush, i tried a semi auto starter in lieu of the standard and vroom,
2332cc on her way. f*&k engine is loud, exhaust reverberating off the gound with 48 ida's.
ran the cam in, then back in the shed for some underbody work and refinement .
advancing the fk10 livened the engine up. ye ha.
|
|
|
ratty 63
A.k.a.: Rossco
Custom Title Time!
Posts: 1083
Threads: 74
Registered: October 1st, 2003
Member Is Offline
Location: Gold Coast, Qld
Theme: UltimaBB Pro Blue ( Default )
Mood: Just cured my shed envy!
|
| posted on July 20th, 2011 at 09:10 AM |
|
|
Awesome news. Glad to hear you have it sorted.
R
|
|
|
