Posts: 462
Threads: 64
Registered: August 29th, 2002
Member Is Offline
Location: east hills, nsw
Theme: UltimaBB Pro Blue ( Default )
Mood: ^___~
posted on August 10th, 2003 at 04:50 PM
stock 1600 type 1 single carb setup
carb, manifold, etc.
what's a reasonable price?
jimmy1812
Learner Dubber
Posts: 10
Threads: 3
Registered: June 22nd, 2003
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
posted on August 10th, 2003 at 05:13 PM
My engine
I bought a 1600 second hand, running compression of 145 in each cylinder. Better than stock. Does this mean it was reconditioned recently? Its got a
solex 30 pict 2, cost me 1000 dude. Dunno how that is price was, but that was including removal of my old engine, and replacing with new engine!
Good luck!
Jimmy
cray
Wolfsburg Wizard
Posts: 462
Threads: 64
Registered: August 29th, 2002
Member Is Offline
Location: east hills, nsw
Theme: UltimaBB Pro Blue ( Default )
Mood: ^___~
posted on August 10th, 2003 at 05:34 PM
well i'm not after a complete engine...
Bizarre
Super Moderator
The artist formerly known as blue74l
Posts: 12780
Threads: 734
Registered: August 25th, 2002
Member Is Offline
Location: Abbotsford, Sydney
Theme: UltimaBB Pro Blue ( Default )
posted on August 10th, 2003 at 09:51 PM
There are 2 things that would determine the value here
1) Manifold.
IF the heat risers are not rusted out AND the passage is clean
2)Carb
What sort? 34, 30??
IF the spindle bushing is tight and not leaking fuel or leaking air
IF both of the above check ok i would say $100 is fair.
