| [ Total Views: 562 | Total Replies: 1 | Thread Id: 9390 ] |
|
|
 Adam_C
Custom Title Time!
Posts: 1180
Threads: 164
Registered: May 22nd, 2003
Member Is Offline
Location: Bargo, 1hr south of syd
Theme: UltimaBB Pro Blue ( Default )
Mood: could be lower
|
| posted on August 14th, 2003 at 08:47 PM |
|
|
1500-1600 compatability
Can 1 . . .
but a 1600 ....
-flywheel
-clutch assy
-dizzy (maybe not ??)
-leads
-exhaust
onto a 1500 engine?
cheers
adz
Adam
Adzslick@iprimus.com.au
|
|
|
matara
Custom Title Time!
Posts: 1342
Threads: 255
Registered: August 25th, 2002
Member Is Offline
Location: Melrose Park, Sydney
Theme: UltimaBB Pro Grey
Mood: 356'd
|
| posted on August 14th, 2003 at 09:09 PM |
|
|
They should all fit
1500 & 1600 engines had the same flywheel (200mm), and can use the same dizzy leads exhaust etc.
As for the exhaust well you may have two risers for the pre-heat tubes and may have to block one off thats all I think
Steve
|
|
|
68AutoBug
A.k.a.: Lee Noonan
Aircooled Master
Beetle Restorer - Experience over 138% - YIKES --
Posts: 11654
Threads: 449
Registered: August 31st, 2002
Member Is Offline
Location: SCONE in UPPER HUNTER VALLEY NSW
Theme: UltimaBB Pro Yellow
Mood: Really Mentally Ill - all of the time -
|
| posted on August 15th, 2003 at 03:54 PM |
|
|
The main differences being: Single port 1500 - to the - dual Port 1600 - so the inlet manifold will be different.. Distributors are
interchangeable... etc... no problems Adz as far as I can see.... Are You talking about a 1600 to 1500 in a Beetle? or type 3 ?
- [size=4]Helping keep Air Cooled VWs on the road - location: SCONE in the Upper Hunter Valley - Northern NSW 320 kms NNW of SYDNEY--- [/size]
|
|
|
Adam_C
Custom Title Time!
Posts: 1180
Threads: 164
Registered: May 22nd, 2003
Member Is Offline
Location: Bargo, 1hr south of syd
Theme: UltimaBB Pro Blue ( Default )
Mood: could be lower
|
| posted on August 15th, 2003 at 05:10 PM |
|
|
have the 1500 here and putting all the good bits fromn the 1600 in the new beetle on it and sticking it in
my main worry was the flywheel
Adam
Adzslick@iprimus.com.au
|
|
|
