| [ Total Views: 592 | Total Replies: 3 | Thread Id: 97700 ] |
|
|
 grogy
Custom Title Time!
Posts: 1000
Threads: 344
Registered: August 16th, 2007
Member Is Offline
Location: Gold Coast
Theme: UltimaBB Pro Blue ( Default )
|
| posted on July 5th, 2012 at 10:29 PM |
|
|
fitting scat shifter............. any takers.............
hi, does the scat shifter fit the same as the standard shifter using the guide plate that goes on bottom of the shifter n mounts to the tunnel.
thanks greg
|
|
|
psimitar
Son of Jim - Creator of Good
Posts: 2506
Threads: 148
Registered: January 1st, 2009
Member Is Offline
Location: North East Melbourne, VIC
Theme: UltimaBB Psyche Blue
|
| posted on July 12th, 2012 at 11:47 PM |
|
|
Should have it's own internal reverse lock out plate. Have you seen if there is any further travel when the reverse lever is pulled?
My old Empi had an internal plate that lifted up for reverse to clear an internal lock out plate. Just needed a little tweaking before bolting tight
down to make sure all gears were available 
madness is in the eye of the beholder  |
|
|
1916baja
Custom Title Time!
Posts: 1990
Threads: 176
Registered: September 20th, 2007
Member Is Offline
Location: Brisbane - Mt Gravatt
Theme: UltimaBB Pro Blue ( Default )
|
| posted on July 13th, 2012 at 03:52 PM |
|
|
pretty sure mine has its own lock out plate... i dont remember but i think i would as it would have been a pain in the ass to line it up if i had to
use the stock one.
|
|
|
grogy
Custom Title Time!
Posts: 1000
Threads: 344
Registered: August 16th, 2007
Member Is Offline
Location: Gold Coast
Theme: UltimaBB Pro Blue ( Default )
|
| posted on July 13th, 2012 at 05:59 PM |
|
|
thanks for the replies, greg
|
|
|
