| [ Total Views: 1526 | Total Replies: 15 | Thread Id: 98720 ] |
|
|
 Giddyarp
Commited Dubber
Posts: 62
Threads: 7
Registered: August 29th, 2012
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on September 7th, 2012 at 07:36 PM |
|
|
1964 Type 1 full Resto (Motor Pulled)
Hi all,
The '64 will have the restoration process started tomorrow !!!! After I move a few things around so I have space to put the body once its lifted off
!!!! I wont be able to go too nuts as yet due to a possible chassis number problem as discussed in the new member section  I am sure everything will be ok but I need to be sure before I pour too much
money into this.. Will post up pics of the old girl before I start so her progress can be tracked 
Dane
|
|
|
gerggl
Wolfsburg Wizard
Posts: 447
Threads: 33
Registered: September 9th, 2010
Member Is Offline
Location: Brisbane
Theme: UltimaBB Streamlined2
Mood: It is what it is !
|
| posted on September 9th, 2012 at 09:58 AM |
|
|
Good luck ... it is a journey ...so is life ... so enjoy!
Greg Gordon-Lane
Brisbane
Vw's are part of life's journey .... get on board!
VW Safari / Thing 1976 - "A work in progress"
Ducati St4s - "Poetry in motion"
|
|
|
Giddyarp
Commited Dubber
Posts: 62
Threads: 7
Registered: August 29th, 2012
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 19th, 2012 at 03:59 PM |
|
|
Some pics finally !!!! As it was when it arrived here !!!
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
|
|
|
Giddyarp
Commited Dubber
Posts: 62
Threads: 7
Registered: August 29th, 2012
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 19th, 2012 at 04:01 PM |
|
|
more
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
|
|
|
Giddyarp
Commited Dubber
Posts: 62
Threads: 7
Registered: August 29th, 2012
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 19th, 2012 at 08:21 PM |
|
|
some more
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
|
|
|
Giddyarp
Commited Dubber
Posts: 62
Threads: 7
Registered: August 29th, 2012
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 19th, 2012 at 08:23 PM |
|
|
........ 3 more !!!!
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
|
|
|
Giddyarp
Commited Dubber
Posts: 62
Threads: 7
Registered: August 29th, 2012
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 19th, 2012 at 08:25 PM |
|
|
In her new home resting peacefully before being stripped Last pic is of
my engine dolly I made !!!
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
|
|
|
Giddyarp
Commited Dubber
Posts: 62
Threads: 7
Registered: August 29th, 2012
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 19th, 2012 at 08:28 PM |
|
|
Dolly needs work as you can see the castor top was too wide making it impossible to fit the trolley jack in....... Need to weld new mounting feet for
the swivel castors :/
|
|
|
Giddyarp
Commited Dubber
Posts: 62
Threads: 7
Registered: August 29th, 2012
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 23rd, 2012 at 10:13 PM |
|
|
Motor Pulled
Finally got started today !!!!!! Pulled the motor and have a new list of things that need attention....
The two top bolts for bellhousing are wrong..... The tinware is pretty tired and will need replacing.... I will need to replace decklid hinge bolts as
no two are the same !!!
Accel cable has been bodged up and the point that the cable attaches to both heater boxes is missing.....
Also the input shaft for the transaxle feels really sloppy as well !!!
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
|
|
|
Giddyarp
Commited Dubber
Posts: 62
Threads: 7
Registered: August 29th, 2012
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 23rd, 2012 at 10:32 PM |
|
|
The drain channel will need replacing as will these wings... Can anyone tell me where the tubes are supposed to run ?????
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
|
|
|
LUFTMEISTER
Veteran Volks Folk
Posts: 2041
Threads: 119
Registered: July 13th, 2005
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
Mood: BRISVEGAS in a state of flux
|
| posted on October 23rd, 2012 at 10:57 PM |
|
|
Good Luck with your project. First item to change is the fuel filter location unless you want all your hard work going up in flames. The weight of the
filter full of fuel over bumpy roads pulls the hose or the brass insert out of the carby and sprays it all over the distributor. Oxygen + Fuel +
Ignition = tears My2c
Customer service is not dead in Australia.
Always after HAZET & MATRA & VW factory tools
|
|
|
Giddyarp
Commited Dubber
Posts: 62
Threads: 7
Registered: August 29th, 2012
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 23rd, 2012 at 11:13 PM |
|
|
Thanks heaps Luftmeister will do....... Yeah engine fire would not be fun at all !!!!!
|
|
|
Giddyarp
Commited Dubber
Posts: 62
Threads: 7
Registered: August 29th, 2012
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 24th, 2012 at 07:26 PM |
|
|
Rear fenders are now off and will remove the fronts after dinner
Want to be at the stage where I am ready to lift the body by the weekend.... Wont lift it off till after I get back from a 5 weeks trip to sea
though... So first week of December the body will be off and then let the fab work commence !!!!!
Areas that need attention found today....
1. One of the nutserts had broken away.... Wont be too hard to repair, Just wont look original with the plan I have !!!! Wont be rough and cant be
seen though...
2. I also have found a rust hole in the body that will be cut out and a new bit of steel welded in its place....
3. The very rear of both heater channels have a small hole in them too.... Thinking of welding in a patch here too..... Thoughts ?????
4. The lips on the bottom right at the rear of the fenders are a bit wafer thin..... Will try and hunt down some wrecked fenders to cut the bits I
need off to repair mine...
Otherwise Im having fun and spend hours dreaming about how cool this will look when its done
|
|
|
Giddyarp
Commited Dubber
Posts: 62
Threads: 7
Registered: August 29th, 2012
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 24th, 2012 at 08:25 PM |
|
|
Here are some pics of the hole I missed on inspection due to a nest that was over the top of it !!!!!
Last pic is of the fender lips that have seen better times......
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
| Error |
| Sorry, you must be a registered user in order to download attachments. |
|
|
|
|
Giddyarp
Commited Dubber
Posts: 62
Threads: 7
Registered: August 29th, 2012
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 24th, 2012 at 10:09 PM |
|
|
Add a repair to the left hand rear bumper mount It will need a replacement
panel I think.....
|
|
|
Giddyarp
Commited Dubber
Posts: 62
Threads: 7
Registered: August 29th, 2012
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on December 1st, 2012 at 10:45 PM |
|
|
Back from sea at last !!!! Busy few weeks.... Gotta go to a different boat now till just before Chrissy..... No rest for the wicked..... Will
hopefully get a chance to get some work started again soon !!!!! Still hoping to have the body off before the big fella in the red suit comes
|
|
|
