| [ Total Views: 1119 | Total Replies: 3 | Thread Id: 104986 ] |
|
|
 brendanwright
Seriously Crusin Dubber
Posts: 141
Threads: 37
Registered: February 18th, 2011
Member Is Offline
Theme: XMBX Pro Green
|
| posted on February 7th, 2014 at 12:09 PM |
|
|
Tri Mil 'Tuck-a-way' exhaust system
Hi All,
Quick question for any type 3 owners that have put a Tri Mil 'Tuck-a-way' exhaust system on their car. I have a 1970 squareback & have just put
a ceramic 'Tuck-a-way' exhaust on it. Looks & sounds fantastic, however the muffler sits quite close up under the rear of the car & close to
the air intake bellows for the fan, the rubber tube actually looks like it's starting to concave inwards & close up a little due to the heat from
the muffler.
Just wondering if anyone has had this problem & if so what did they do to rectify it??
I'm a little concerned that if the air intake bellows starts to melt & close up it will do some serious damage to the engine.
Thanks for any constructive feedback, much appreciated.
regards,
Brendan
|
|
|
empi
A.k.a.: Empstar
Compulsive Aussie Vee Dubber
Posts: 4131
Threads: 178
Registered: August 27th, 2002
Member Is Offline
Location: melbourne
Theme: UltimaBB Pro Blue ( Default )
Mood: thunderous
|
| posted on February 7th, 2014 at 02:56 PM |
|
|
Aluminium heat shield like on a modern car
"If at first you don't succeed, skydiving is not for you." - Anonymous  |
|
|
cruiser
Seriously Crusin Dubber
Posts: 193
Threads: 17
Registered: August 5th, 2007
Member Is Offline
Location: Way out west, Perth.
Theme: UltimaBB Pro Blue ( Default )
|
| posted on February 23rd, 2014 at 12:49 AM |
|
|
I have been running this exhaust for a couple of years now and it's fine. Seem to clear the bellows by about 2 or 3cm. The rear apron was very close
but I just pulled it back a little until it was just clearing.
Is your bellows an original or repro?
|
|
|
brendanwright
Seriously Crusin Dubber
Posts: 141
Threads: 37
Registered: February 18th, 2011
Member Is Offline
Theme: XMBX Pro Green
|
| posted on February 23rd, 2014 at 11:37 AM |
|
|
Hey cruiser, I'm not too sure mate.....I think it's probably a piece of sh-t repro one that looks to be quite old, might just get a new one and see
how it goes. I have another friend who has the same exhaust and his also looks to be ok.......
Thanks for the feedback mate, much appreciated
|
|
|
