| [ Total Views: 670 | Total Replies: 5 | Thread Id: 108307 ] |
|
|
 ACE76
Seriously Crusin Dubber
Posts: 105
Threads: 19
Registered: August 4th, 2005
Member Is Offline
Location: Victoria
Theme: UltimaBB Pro Purple
Mood: ACE 30 FOR SALE!
|
| posted on February 5th, 2015 at 03:03 PM |
|
|
Any cure for Sticking Hydraulic Tappet ?
Hi All mechanical experts! Is there an easy potential cure for an apparently sticking hydraulic tappet? (In a conventional water-cooled engine
that is, not VW.) eg a bottle of a magic-additive-something to add, that might free it up? The tappet noise occurs at low rpm, when cold, for about
a minute or so, but seems to disappear after that. We have so far tried engine-flush; changed to somewhat thinner oil (from 25W-60 down to 20W-50,
then 20W-40), and added some molybond -- all with no change at all to the noise. If oil viscosity contributes to such noise, does going thicker or
thinner improve it - or make no difference? It's an old engine in apparently good condition that may have been sitting around unused for a while.
ACE 30 & ACE 40 oil: specially formulated for your Air Cooled Engine...
Delivery free Outer Eastern Melb. & Dandenong Ranges.
from$19 for 2.5L (spot-on for 1 fill, re-use bottle to measure), or $29 for 5L (2 fills)
|
|
|
vlad01
Compulsive Aussie Vee Dubber
Posts: 4270
Threads: 109
Registered: June 3rd, 2010
Member Is Offline
Location: Kyneton, VIC
Theme: UltimaBB Pro Blue ( Default )
Mood: Side ways
|
| posted on February 5th, 2015 at 09:01 PM |
|
|
thinner oil improves cold hydo tappet/lifter noise as it allows them to fill and actuate more easily and quicker when cold.
But if they are noisy all the time with correct grade of oil at low rpm can be oil pressure problems but more often they have faulty check valves or
physical wear/damage resulting in inoperable hydraulics, usually from over revving too much like i did which killed all my hydro roller lifters 
Mine come somewhat good after warm up, but clatter about just off idle and come good again at higher rpm. thinner oil helps but at cost of engine wear
ran 10w instead of 25W as stated by the owners manual. I run 15W which worked out good. little engine wear and not too noisy, good in summer and
winter. Winter is a killer in Macedon ranges and thick oil. might as well not have any oil at all and use honey as its thinner.
Anyway, replace them is the best bet if oil doesn't fix it immediately.
71 notchback,
Past owner of, 70 NB, 73 SB and 72 FB TLE |
|
|
 helbus
A.k.a.: Pete S
Super Administrator
Mad fabricator, paint and body
Posts: 7386
Threads: 312
Registered: September 1st, 2002
Member Is Offline
Location: In the garage chopping cars into bits
Theme: UltimaBB Pro Blue
Mood: In the thinking chair
|
| posted on February 5th, 2015 at 09:29 PM |
|
|
I went to the pick and go wreckers and got a full set of real clean OHC rocker sets for our Suby engine. The whole set cost me $24 and it made the
engine go from clattrey until warm, and changed it to not even a tick after firing up.
|
|
|
psimitar
Son of Jim - Creator of Good
Posts: 2506
Threads: 148
Registered: January 1st, 2009
Member Is Offline
Location: North East Melbourne, VIC
Theme: UltimaBB Psyche Blue
|
| posted on February 5th, 2015 at 10:21 PM |
|
|
old lifters can stick due to build up of tarnishes and this is enhanced if the engine hasn't run in a pretty long time. If the lifter isn't worn
then after soaking in brake cleaner for a few days and re-priming then brings em good but you won't know unless you remove them and give it a whirl
so if a set from the wreckers is that cheap then probably the easiest option 
madness is in the eye of the beholder  |
|
|
ancientbugger
Custom Title Time!
Posts: 1986
Threads: 191
Registered: March 24th, 2004
Member Is Offline
Location: sunshine coast
Theme: UltimaBB Pro Yellow
|
| posted on February 6th, 2015 at 09:30 AM |
|
|
My son had sticking lifters in his Skyline (it appears to be a common problem) and what he did was to remove them and soak them in thinners then as
psimitar says reprime them and refit. As I say it worked on a Skyline.
|
|
|
ACE76
Seriously Crusin Dubber
Posts: 105
Threads: 19
Registered: August 4th, 2005
Member Is Offline
Location: Victoria
Theme: UltimaBB Pro Purple
Mood: ACE 30 FOR SALE!
|
| posted on February 6th, 2015 at 10:11 PM |
|
|
Thank Guys. Was hoping for an easy cure in a bottle, rather than dismantling the valve gear & removing the tappet/s, but realise that may have
to be done if nothing else works! (Will try thinner oil first.)
ACE 30 & ACE 40 oil: specially formulated for your Air Cooled Engine...
Delivery free Outer Eastern Melb. & Dandenong Ranges.
from$19 for 2.5L (spot-on for 1 fill, re-use bottle to measure), or $29 for 5L (2 fills)
|
|
|
