| [ Total Views: 729 | Total Replies: 3 | Thread Id: 109995 ] |
|
|
 mossman
Commited Dubber
Posts: 73
Threads: 30
Registered: April 6th, 2013
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 22nd, 2015 at 12:27 AM |
|
|
6 Volt Starter into 12 Volt Gear Box
Hey Guys,
I'm having trouble seating a starter bush converting the 6volt starter to the 12volt gearbox (the thin bush). It looks like it stops at the end of
the machined area in the gearbox but sticks out ~2mm. The 6 volt starter motor sits out from the box and doesn't look like it will bolt up tight.
A few gentle taps but the start bush wont go any further.
The bush was bought locally in Brisbane.
Has anyone else had this problem? Is there a trick? Should the bush be shorter?
Cheers
Mark
|
|
|
dangerous
A.k.a.: Dave Butler Muffin Man
23 Windows of Awesome
Posts: 5901
Threads: 178
Registered: January 6th, 2005
Member Is Offline
Location: Gold Coast
Theme: UltimaBB Pro Blue ( Default )
Mood: 591
|
| posted on October 22nd, 2015 at 07:26 AM |
|
|
I have never used one,
but I believe some are meant to sleeve the starter shaft,
and run in the magnesium.
| Quote: | Originally
posted by westi
That's mad Alan.
|
|
|
|
psimitar
Son of Jim - Creator of Good
Posts: 2506
Threads: 148
Registered: January 1st, 2009
Member Is Offline
Location: North East Melbourne, VIC
Theme: UltimaBB Psyche Blue
|
| posted on October 22nd, 2015 at 08:00 PM |
|
|
So you removed the old bush? IIRC it's not a blind hole and is the same diameter it's whole length so should just tap in until flush.
I've done both a std 6v and 12 to 6v conversion bush and not had a problem with either.
madness is in the eye of the beholder  |
|
|
mossman
Commited Dubber
Posts: 73
Threads: 30
Registered: April 6th, 2013
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 22nd, 2015 at 10:06 PM |
|
|
Thanks psimitar. Old bush was removed. Seemed like the hole in the gearbox wasn't reemed all the way through and the new bush was longer than the
original bush. So trimmed off the excess length, smoothed out the edges, reinstalled and now it all fits.
|
|
|
