Posts:
Threads:
Registered: January 1st, 1970
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
posted on February 11th, 2004 at 07:57 AM
dropping a 2L with auto
i'm about to drop my 2L and freshen it up. 77 bay.
Q: is there any difference between manual and auto for engine extraction with respect to lowering the box ??
Q: to replace the auto seal, does the torque converter just slide out ??
thanks,
Dunc.
kombikim
A.k.a.: Kim
Custom Title Time!
disfunctionally capable
Posts: 1521
Threads: 84
Registered: December 18th, 2002
Member Is Offline
Location: Sydney, Concord West
Theme: UltimaBB Pro Blue ( Default )
Mood: always bleary
posted on February 11th, 2004 at 08:07 AM
I assume you are leaving the transmission in, in that case not really any different but you must make sure the convertor is wired or tied back onto
transmission after unbolting it from drive plate, otherwise it will drop off when you pull the motor & you will have oil every where, this answers
your second question
Please, I need drivers side window regulator (winder mechanism) for my '54
seagull
Compulsive Aussie Vee Dubber
Posts: 4979
Threads: 752
Registered: December 25th, 2003
Member Is Offline
Location: PerthWA
Theme: UltimaBB Pro Blue ( Default )
posted on February 13th, 2004 at 09:49 PM
Ok
A old vw man told me to fit two seals ,I have done this and never had oil run out from that day, make sure you wire the converter in the housing when
you remove the donk .
Looking for that special lady : PM me for coffee & cake
